Outdoor Leisure TD101 Owner's Manual page 5

ASSEMBLy
Continued
1. Locate table heater base and 3 lower table
support pillars with holes on one side only.
Making sure holes in pillars are oriented as
shown in Figure 3, slide support pillars into
base and attach with screws (A) and wash-
ers (B) through bottom 2 holes as shown.
2. Position lower table panel and table control
panel onto base assembly as shown in Figure
4. Make certain lower table panel is on side
of base with wheels. Using bottom 3 sets of
holes only, attach panels to support pillars
with 12 screws (C) (see Figure 4). Attach
ignitor ground wire with 1 screw as shown in
Figure 4 (ignitor installed in step 4).
3. Top sets of screws (C) will insert through
panels, through support pillars, then into
pillar support connectors as shown in
Figure 4 (6 screws). Make sure pillar sup-
port connectors are oriented as shown in
Figure 4. The side of connectors with one
hole should be facing outside heater and
hole should be at the top. For support con-
nectors closest to front opening, second
screw will only install through panels and
support connectors. Second screw will
secure connector (see Figure 4).
Ignitor Grounding Wire
Lower Table Panel
Pillar
Support
Connector
Wheel
118992-01G
Figure 4 - Attaching Side Panels and Ignitor
www.desatech.com
4. Install electronic ignitor through control
panel as shown in Figure 4. Screw retainer
ring and ignitor cap on from outside panel.
Attach ignitor ground wire to ignitor.
Support
Pillar
Heater
Base
Figure 3 - Installing Support Pillars into
Electronic
Ignitor
Hole for
Control Valve
Table Control
Panel
Washers
Screws
Base
Screw Installs
Through Pillar
Support and
Connector Only
5