Advertisement
www.martelcorp.com
e-mail: sales@martelcorp.com
Tel: (603) 434-1433
Fax: (603) 434-1653
Martel Electronics
3 Corporate Park Drive
Derry, NH 03038
Rev C 1/13 P/N 0219057
800-821-0023
MECP100
Pneumatic Hand Pump
Operating Instructions
The Martel MECP100 Hand Pump is designed to be a simple to use
pressure and vacuum source for calibrating process control
instrumentation. Combined with one of our pressure calibrators, the
MECP100 makes a complete Pressure/Vacuum Calibration System.
Operation
The drawing shows the operation of the controls on the MECP100. The
pump is designed for use with ambient air only. If there is a possibility that
contaminants may enter the pump the optional filter (Martel P/N 54-54067)
should be installed at the output fitting.
CAUTION: Do not connect the pump to a pressure source.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Martel MECP100
Summary of Contents for Martel MECP100
-
Page 1: Operating Instructions
MECP100 Pneumatic Hand Pump Operating Instructions The Martel MECP100 Hand Pump is designed to be a simple to use pressure and vacuum source for calibrating process control instrumentation. Combined with one of our pressure calibrators, the MECP100 makes a complete Pressure/Vacuum Calibration System. - Page 2 11. Release the pressure and repeat several times to ensure that the o-rings seat properly. Pump Valve Assembly Cleaning Instructions Occasionally, the MECP100 may not work properly due to dirt or other WARRANTY contamination of the internal valve assembly. Use the following procedure for cleaning the valve assembly.
Need help?
Do you have a question about the MECP100 and is the answer not in the manual?
Questions and answers