Summary of Contents for Klarstein 10000502
-
Page 1: Metal Detector
Please read before using this equipment Klarstein Metal Detector Art.10000502 OWNER'S MANUAL... -
Page 2: Quick Start
Quick Start 1. Place the unit on top of a table/ flat surface, which doesn't contain metal. Remove any jewelry you may be wearing. 2. Install the batteries - 6 AA (not included). 3. Power on 4. Set the VOLUME about one - thirds. The power knob is also the volume knob. - Page 3 FEATURES TREASURE HUNTER' CODE With your Metal Detector, you can hunt for OF ETHICS coins, relics, jewelry, gold, and silver just about anywhere. This metal detector is very versatile and easy to use. All treasure hunters might be judged by the example you set.
-
Page 4: Adjusting The Search Coil
PREPARATION INSTALLING STAY BAR ADJUSTING THE SEARCH COIL 1. Pull the trapeziform raised part at stay bar, into the fillister at the housing Loosen the knobs at the search coil's end, then adjust the search coil to the desired angle. (The search coil should bc parallel with the ground.) Tighten the knobs just enough to keep the search coil from rotating 2. - Page 5 1. If the detector is on, turn VOLUME (on the Cautions: control housing) to OFF. (The control • Always remove old or wcak batteries; clicks.) batteries can leak chcmicals that can destroy electronic parts. • If you do not plan to use the detector for a week or more, remove the batteries.
-
Page 6: Using Earphones
USING EARPHONES can lead to permanent hearing loss. You can connect a pair of stereo earphones Once you set the volume, do not • increase it. Over time, your ears adapt to the detector so you can listen to it privately. to the volume level, so a volume level Using earphones also saves battery power and that does not cause discomfort might... -
Page 7: Operation
OPERATION Your Metal Detector distinguishes between 3. Hold the search coil about 1 foot away ferrous and nonferrous metals. Ferrous metals from the ground and any metal object, contain iron, while non-ferrous metals such as hold down the red button on the handle, gold, silver, copper, platinum, aluminum, lead, and slowly rotate TUNE left and right and zinc do not. -
Page 8: Testing And Using The Detector
TESTING AND USING THE Notes: DETECTOR • The scarch coil will not detect without To lcam how thc detector rcacts to different motion. You raust move the object metals, you should test it beforc you usc it since you are not sweeping with the thc Erst time. -
Page 9: Outdoor Testing And Use
Outdoor Testing and Use Search Coil Sweeping Hints: 1. Find an area on the ground outside where Never sweep the search coil as if it were • there is no metal. a pendulum. Raising the search coil 2. Place a sample of the material you want while sweeping or at the end of a sweep the detector to find (such as a gold ring or causes false readings. -
Page 10: False Signals
False signals can be caused by trashy Note: Each time you use the detector in a ground, electrical interference, or large different area, you must adjust irregular pieces of junk metal. False DISCRIMINATION. Each scarch location signals are usually broken presents ncw challenges. -
Page 11: Pinpointing A Target
• The depth of the object Repcat Steps 1-2 at a right angle to thc • The amount of iron in the object original scarch line, making an "X" • The size of the object pattern. The target should bc directly below the "X"... -
Page 12: Troubleshooting
TROUBLESHOOTING If your detector is not working as it should, follow the suggestions below to see if you can eliminate the problem. Problem Suggestions The detector displays falsc You might bc swccping the detector's scarch coil too fast or signals. at the wrong angle.