Procedure To Transmit - Ranger RCI-2985DX User Manual

DX
RCI-2985
DX
RCI-2995
(3) Set the VOL. to a comfortable listening level.
(4) Set the MODE switch to the desired mode.
(5) Listen to the background noise from the speaker. Turn the SQUELCH knob slowly clockwise until
the noise just disappears. The SQUELCH is now properly adjusted. The receiver will remain quiet
until a signal is actually received. Do not advance the control too far or some of weaker signals will
not be heard.
(6) Set the CHANNEL selector switch to the desired channel.
(7) Set the RF GAIN control fully clockwise for maximum RF gain.
(8) Adjust the CLARIFIER control to clarify the SSB signals or to optimize AM/FM signals.

3.3.11 PROCEDURE TO TRANSMIT

(1) Select the desired channel of transmission
(2) Set the MIC GAIN control fully clockwise.
(3) If the channel is clear, depress the push-to-talk switch on the microphone and speak in a normal
voice.
- 12 -
CHAPTER 3
INTRODUCTION