Sony Playstation 2 Repair Manual page 18

C. Use your knife to cut the warranty tape that is covering
the seam between the back and the top cover. (By the
power switch). Just trace the seam through the tape with the
knife so that it will not be holding you back when you go to
remove the top later.
Using the normal sized Phillips head screwdriver, Make sure all of the screws are removed, and put them
D.
aside.
NOTE: Some of the screws are longer than others. It is VERY IMPORTANT that you remember where the
longer screws go. You may want to mark the holes with a piece of tape or some other way so that you will know
which holes the long screws go into. If you do not remember where the long screws go, you could put a hole
through a circuit board by trying to force the long screw in where it is not supposed to be.
E. The PS2 shell should now be ready to remove.
ONLY the UPPER side (with the PS2 logo) needs to
be removed for this step - Leave the BOTTOM side
on. WARNING-Be very careful when taking the
upper shell off, or you could damage the PS2.
Place the PS2 horizontally, with the PS2 logo facing
up and the front facing you.
Pull up on the cover from the back and work it free and lift about 1/2 inch. Move the shell forward a little,
sideways, so that the Eject/Reset buttons are not blocking the shell and the CD tray comes clear, and it can be
lifted off. Just play around with it a little and you should get it.
18