BabyLove EZY GROW EP Instruction Book
  1. Manuals
  2. Brands
  3. BabyLove Manuals
  4. Automobile Accessories
  5. EZY GROW EP
  6. Instruction book

BabyLove EZY GROW EP Instruction Book

Harnessed child restraint 6 month to 8 years (approx)
Hide thumbs

Advertisement

Table of Contents

INSTRUCTION BOOK
Harnessed Child Restraint
6 month to 8 years (approx).
Series No. BL90G/A/2013
IMPORTANT:
KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EZY GROW EP and is the answer not in the manual?

Questions and answers

Summary of Contents for BabyLove EZY GROW EP

  • Page 1 INSTRUCTION BOOK Harnessed Child Restraint 6 month to 8 years (approx). Series No. BL90G/A/2013 IMPORTANT: KEEP THIS BOOKLET IN THE PLACE PROVIDED ON THE CHILD RESTRAINT...
  • Page 2 SEATBELT QUICK SETUP SEATBELT QUICK SETUP...
  • Page 3 INTRODUCTION INTRODUCTION To be used only in a forward-facing position by a child whose shoulders are above the lower shoulder Chỉ được sử dụng ở vị trí hướng mặt về phía trước cho em nào có vai ở trên vạch ghi độ cao của vai ở...
  • Page 4 INTRODUCTION INTRODUCTION 肩膀超过靠下肩高标记的婴儿（大约6个月的宝宝）只采用前向式安装，直到儿童肩膀达到 के व ल उस शिशु द् व ारा मात् र सामने की दिशा की स् थ िति मे ं प् र योग किया जाना चाहिए जिसके कन् ध े कन् ध े के निचले भाग से ऊपर आ गए हों 靠上的肩高标记（大约8岁的儿童）。...
  • Page 5 The child should not sit in this forward facing child restraint until their neck muscles are able to support their head. Babylove recommends that you keep your child in a rearward facing restraint for as long as possible (up to approximately 12 months or more).
  • Page 6 IMPORTANT : • Regularly check the restraint components, straps and other fitments for correct function and • Fit the restraint firmly to the car seat. condition. Seek prompt repair. • Fit the harness firmly to the child. • IF AN AIRBAG IS FITTED IN THE SEATING POSITION WHERE THE CHILD RESTRAINT IS TO BE FITTED, FOLLOW THE VEHICLE MANUFACTURERS WARNINGS AND INSTRUCTIONS.
  • Page 7 To approximately 8 years of age. From approximately 6 months of age However, Babylove recommends that you keep your child in a rearward facing restraint for as long as possible (up to Marker B Larger Child - UPPER SHOULDER HEIGHT MARKER approx 12 months).

  • Page 8: Special Features

    SHOULDER HEIGHT LABELS & THE NEXT STEP SPECIAL FEATURES Next type of restraint that can be used in the car for your child. When your child has outgrown the seat, you can then either use: Use a booster seat suitable for children up to 8-10 years of age and a Child Harness suitable for use with the booster seat.

  • Page 9: Suitable For Use

    SPECIAL FEATURES SUITABLE FOR USE TO BE USED WITH A LAP SASH OR LAP ONLY SEAT BELT IN THE BACK OF MOST CARS WITH FORWARD-FACING SEATS. To be used only in a forward-facing position by a child whose shoulders are above the lower shoulder height marker (approximately 6 months of age) until the child’s shoulders reach the upper shoulder height 19 20 marker (approximately 8 years of age).

  • Page 10: How To Use

    HOW TO USE HOW TO USE ADJUSTING SHOULDER HARNESS STRAPS TOP TETHER ATTACHMENT Refer to your vehicle owner’s manual for the location of the anchor fitting in the car. If the vehicle is not Correct fitment of the harness is very important to pro tect the child. fitted with a child restraint anchor fitting then refer to page 36 for the installation of the anchor fitting The harness must fit firmly around the upper torso of the child and be provided with this child restraint.
  • Page 11 HOW TO USE HOW TO USE SETTING UP THE HARNESS ADJUSTING THE CROTCH BUCKLE HEIGHT A. Put the restraint on a flat ground and supported from behind so that it will not tip over. The seat has the crotch straps fitted in the shortest length position as supplied.
  • Page 12 HOW TO USE HOW TO USE E. Thread the shoulder straps through the slots (E). ADJUSTING HARNESS STRAP HEIGHT & HEADREST: - STEPS IN CHANGING Engage the straps to the metal strap connector (see B). SHOULDER STRAP SLOTS A. If installed in the vehicle, remove the restraint from vehicle as The harness straps must always be routed straight through the instructed on page 27.

  • Page 13: How To Set Up

    HOW TO SETUP HOW TO SETUP INSTALLING INTO VEHICLE (FORWARD-FACING) (UPRIGHT OR RECLINED) C. Position restraint centrally to the chosen car seat position. The restraint must be in a forward facing direction. Some vehicle seat fabrics (particularly velours) may be damaged by a child restraint used A.
  • Page 14 HOW TO SETUP HOW TO SETUP G. Pull the top tether adjustment strap (C) to remove any D. Lengthen the top tether strap and connect the Attachment Clip attachment clip to the car's upper anchorage point in the slack but do not tighten. Roll up excess strap and use Pull Adjustment pocket at the top of the cover to store the excess strap.
  • Page 15 HOW TO SETUP HOW TO SETUP C. Fit either harness buckle tongue into PLACING CHILD IN THE RESTRAINT the harness buckle followed by the other tongue until a click is heard. A. Lengthen harness by lifting the adjuster lever while pulling Should the second tongue not on both shoulder straps until the harness will accommodate insert then press the red button and...

  • Page 16: Care And Maintenance

    CARE & MAINTENANCE CARE & MAINTENANCE BUCKLE OPERATION REGULAR CARE OF THIS RESTRAINT: To ensure the buckle remains operational the inside of the buckle must be kept free of liquids, sand, Please check the following items regularly to ensure the safety of your child: dirt, fluff, food or similar substances.

  • Page 17: Accessories & Features

    ACCESSORIES & FEATURES ACCESSORIES & FEATURES ONLY USE BABYLOVE SEAT COVERS THAT ARE DESIGNED AND TESTED FOR USE WITH THIS TO CLEAN THE COVER PRODUCT. The restraint has a flame retardant cover which is removable for cleaning. Cleaning instructions are on the care label attached to the cover.
  • Page 18 Cup Holder can be removed if not instructions apply to accessories that may be supplied with this restraint at point of purchase. If not, a in required. variety of Babylove accessories are available from various retailers of Nursery Elegance products. IMPORTANT: Cup holder CROTCH PAD (IF FITTED) Only use for holding cups, bottles and drink cartons.
  • Page 19 Front of Vehicle Extension Strap distance to be measured. RESTRAINT ANCHORAGE POINTS Length 300mm (Use Babylove part K304 or equivalent) For Sedans only - Drill 9mm diameter hole in the parcel UPPER ANCHORAGE Length 600mm (Use Babylove part K305 or equivalent)

  • Page 20: In Case Of Accident

    HOOKED ONTO ANY OTHER OBJECT. Centre line of Fig.3. seating position VEHICLE INSTALLATION ACCESSORIES (Available from retailers of Babylove products) EXTRA ANCHOR KITS: Are available if using the restraint in additional vehicles. Re-order number: K402 EXTENSION STRAPS: May be required for vehicles without a fixed parcel shelf.
  • Page 21 We reserve the right to alter this product without notice in our constant endeavor for improvement. ©2007-2014 Nursery Elegance Pty. Ltd. Babylove Trademarks are the property of Nursery Elegance Pty Ltd. This product is covered by Australian and Overseas patents and applications.

Table of Contents

Save PDF