Makita JR3030 Instruction Manual page 7

Hide thumbs Also See for JR3030:

ASSEMBLY

Installing or removing the saw blade

CAUTION:

*Always be sure that the tool is switched off and unplugged before installing or removing

the blade.

*Always clean out all chips or foreign matter adhering to the blade, blade clamp and/or

slider. Failure to do so may cause insufficient tightening of the blade, resulting in a seri-

ous injury

For JR3030

To install the blade, loosen the screw on

the blade clamp with the hex wrench 4 pro-

vided. Insert the blade between the blade

clamp and the slider so that the pin on the

slider fits into the hole in the blade shank. If

the pin cannot easily fit into the hole,

remove the hex wrench from the screw

and then try again. After the pin fits proper-

ly into the hole, tighten the screw securely

while making sure that the blade cannot be

extracted even though you try to pull it out.

CAUTION:

you tighten the screw without the pin on

the slider fitting properly in the hole in the

blade shank, the pin or the blade shank will

be damaged. This may cause the blade to

be ejected unexpectedly during operation.

This can be extremely dangerous.

Hex wrench

Loosen

Slider

To install the blade, loosen the screw on the blade clamp with the hex wrench 4.

Table of Contents

Jr3030t