Summary of Contents for Strong xenon
- Page 1 XENON POWER SUPPLY Compact Model Type 62-80100 Issue 12/98 STRONG INTERNATIONAL a division of Ballantyne of Omaha, Inc. 4350 McKinley Street Omaha, Nebraska 68112 USA Tel 402/453-4444 • Fax 402/453-7238...
- Page 3 NOTICE REFER ALL SERVICING of this unit to an authorized Strong International Equipment Dealer. The 62-80100 Switching Xenon Power Supply employs solid state circuitry requiring sophisticated diagnostic equipment not gener- ally available to field service personnel. Hazardous high voltages exist within...
- Page 4 CAUTION: This equipment operates at hazardous voltages, and should be operated by qualified, trained personnel only. Do not remove power supply cover panels when the unit is energized. Ground prong keyed...
- Page 5 Optional Lamphouse Termination Panel as supplied for units without MS Connector Assembly. Control Circuit Terminals Assembly No. 62-70030 PC Board 62-70028 Current Control Receptacle Fine Coarse...
- Page 7 RESET GREEN RESET 20 VDC: VIN: FUSE: TEMP: VIN: MODULE: STRIKE: RIPPLE:...
- Page 8 TEMP...
- Page 10 See Figure 3 FIGURE 1...
- Page 12 FIGURE 2...
- Page 14 CURRENT CONTROL (to Item 18): 62-70028 Plug-In PC Board Assembly (no Cable) 62-70032 Potentiometer & Cable Assembly (Remote) FIGURE 3...
- Page 16 DB 15 Connector Pin # 1. Com Signal 2. I Signal (20mv/a) 3. GO Signal Input 4. Power Section Fault 5. Inhibit Fault 6. (not used) 7. +9 V. 8. +9 V. Return 9. V Signal (20 mv/v) 10. +9 V. Return 11.