POWERED SUBWOOFER
FIGURE 1 - CONNECTING TO A COMPONENT'S SUBWOOFER OUTPUT
SUBWOOFER
SUB / MONO OUT
REF
SURROUND PROCESSOR OR RECEIVER
This will give you better bass quality than using the speaker inputs, because it bypasses your amp or receiver's
amplifier stage. To connect the subwoofer in this way, simply run one or a pair of shielded RCA - RCA interconnect
cables from the output jacks on your component to the "LINE LEVEL" jacks on the Subwoofer's backplate. If you run
one cable, connect it to the "LEFT" input jack. See Figure 1. It is not necessary to use both input jacks on the sub-
woofer.
FIGURE 2 - CONNECTING TO A STEREO AMP OR PREAMP
SURROUND PROCESSOR OR RECEIVER
MAIN PRE OUT
LEFT
RIGHT
REF
LEFT
RIGHT
MAIN INPUT
- RIGHT +
- LEFT +
+
+
6