Satellite Speaker Wiring Options; Figure 3 To An Amp Or Receiver Using Speaker Wires; Figure 4 Satellite Speaker Wiring (Optional) - MK Sound K-10 Operation Manual

powered subwoofers
FIGURE 3 - TO AN AMP OR RECEIVER USING SPEAKER WIRES
AMPLIFIER OR RECEIVER
NOTE: See Fig. 4 for additional options
IMPORTANT NOTE FOR DOLBY PRO LOGIC SURROUND SYSTEMS:
When the Subwoofer is connected to the Left and Right amplifier outputs, the Center channel WIDE/
NORMAL switch MUST be set to the NORMAL mode. If the switch is set to the WIDE mode, the bass content
of the Center channel will not be fed to the Subwoofer, and a significant amount of bass in the program material
will not be reproduced.
If you use speaker wires to connect the subwoofer, you have two options for the Satellite speakers.
1. Connect both the Satellite speakers and the subwoofer direct to your amp or receiver, with one
set of wires running to the Satellites and another set to the Subwoofer. See Figure 4, below.
FIGURE 4 - SATELLITE SPEAKER WIRING (OPTIONAL)
AMPLIFIER OR RECEIVER
+
If your receiver or amp has two sets of speaker outputs, you may connect the
Satellite speakers to one set of outputs and the Subwoofer to the other set.
+ +
(NOT DOLBY DIGITAL 5.1)

SATELLITE SPEAKER WIRING OPTIONS

SATELLITE SPEAKERS
BASS LEVEL
LEFT/MONO
REFERENCE
+3 dB
- 3 dB
- 6 dB +6 dB
+9 dB
!
RISK OF ELECTRIC SHOCK
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
BASS LEVEL
REFERENCE
- 3 dB +3 dB
- 6 dB +6 dB
+9 dB
!
AVIS:
RISQUE DE CHOC ELECTRIQUE. NE PAS OUVRIR.
ATTENTION:
DEBRANCHER AVANT DE
REMPLACER LE FUSIBLE.
UTILIZER UN FUSIBLE
DE RECHANGE DE MEME TYPE.
+
LOW PASS FILTER
RIGHT PHASE (Hz)
VARIABLE
+
75
INPUT
100
60
-
BYPASS
50 125
CAUTION
DO NOT OPEN
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
T
120 VAC 50/60 Hz 2 AMP
SLOW-BLOW
LOW PASS FILTER
LEFT/MONO RIGHT PHASE (Hz)
VARIABLE
+
75
INPUT
100
60
-
BYPASS
50 125
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
DISCONNECT SUPPLY CORD
BEFORE CHANGING FUSE.
REPLACE FUSE ONLY
WITH SAME TYPE.
120 VAC 50/60 Hz T
2 AMP
SLOW-BLOW
page 8