Cleaning The Filter; Replacing The Uvc Bulb - Hunter 40884 Owner's Manual

Maintenance continued
3. Gently remove the
carefully removing it from the
secure it to the
4. Check the side of the
for particle coverage
5. If the
submerged in warm soapy water to clean
and submerge the
6. When complete
water and allow to dry completely
Note : Wet parts placed into the unit can cause
damage to the filters and or the motor of the air purifier
7. Reinstall the
8. Replace the rear grill
normal operation .

CLEANING THE FILTER:

T urn the air purifier off and disconnect from the outlet.
1.
2. Remove the
gently pulling the
and lift the
3. Remove the
arrow printed on the side of the filter. The
be reinstalled with the same orientation. Figure 9.
With a vacuum cleaner and upholstery brush
4.
attachment, clean the filter until all particles are
removed. Do not use water or liquids to clean the
HEPA Type filter.
Reinstall the
5.
Replace the
6.
normal operation. normal operation.

REPLACING THE UVC BULB :

Follow these instructions to remove and replace the
UVC
1. Unplug the unit from the wall outlet
2. Remove the
gently pulling the
and lift the
8
(
from the
Figure
. 8.
facing the
.
needs to be cleaned it may be
several times to clean
rinse the
,
.
The unit is now ready for
.
on the back of the unit by
away from the unit
away. Figure 7.
from the unit. Note the directional
The unit is now ready for
on the back of the unit by
away from the unit
away Figure
.
44134-01 • 03/20/2014
)
, by
that
,
. Gently lift
.
with warm
.
.
will
.
7.
Filter
Supports
Figure 8
Figure 9
screw
Figure 10
spacer
Figure 11