Picture apliances ............. 3 Before first use ............4 Tips for saving electrict energy ........ 6 Important warnings ..........7 Installation and connection........8 Connection to the electricity grid ......9 Device operation .............11 Maintenance and cleaning ........14 Troubleshooting ............17...
Picture appliances Equipment apparatus can be changed depending on the model of the appliance. The label with basic information about the appliance is located in the interior or on the back of the device.
Before first use Before plugging in electrical voltage, a machine is idle for approximately 12 hours. This reduces the possibility of improper action due to the impact of transport on cooling system. Unpacking Thoroughly clean the appliance, especially the interior (Follow advice from the chapter Cleaning).
Page 5
Possible to disable the lock To avoid the danger posed to children from choking. • Appliances containing refrigerant and insulation ingredients that require special degradation, thus removing appliances connect with authorized and certified municipal company, or contact the dealer. because the risk of environmental pollution, be careful not to damage the pipe in the bottom of the apparatu.
Tips for saving electric energy • Do not close the appliance door more frequently than necessary. This is especially important in hot or humid weather. • Periodically check that the camera has secured a sufficient cooling degree (smooth air circulation behind the appliance). •...
Important warnings The appliance is properly connected to the power grid (refer to section Connection to the power network). Always unplug from the mains prior to repairs, before cleaning and be- fore replacing the light bulb. When switching off the machine, grasp the plug, and do not pull on the supply cable.
+ 16 ° C to + 38 ° C CC5 Tropic from +16°C to +42°C Unique Wine Cooler 400 is in CC5 Tropic this. class Do not place the device near a heating and not ispostavljajte by direct sunlight rays. At short distances from the source heat, use the isolating plate.
Levelling appliances Setting up appliances • Larger Phillips screwdriver or by hand from the The front left leg outside Turn the legs and thereby raise or lower the machine and straighten it. • Accurately determine the position of the camera, which should in vertically gently sloping to the back or front feet should be more twisted by approximately 1 cm from the last two legs and to showcase stands...
Page 10
Connecting to electricity grid The appliance plug in the mains connecting the supply cable. The wall socket must be Grounding (security socket). prescribed rated voltage and frequency are indicated on the label with basic data on the appliance. Connecting to the power supply and grounding appli- ances must be made according to current standards and regulations.
Device operation Regulating Temperature-thermostats Dixell XR03CX The temperature electronic display cases for drinks you can regulated between 2 ° C and 18-20 ° C. Showcase for drinking place in the room, where the temperature drops below 16 ° C or exceeds 42 °...
Page 12
The screen display shows the actual temperature the temperature in the glass case on the first shelf. Actual temperature may differ from the selected, depending on the frequency of opening the door of the wine, and ambient temperature. After a change of regulation, before the new changes wait 12 to 24 hours to reach Showcase regulated temperature.
Page 13
Slide shelves All shelves can draw, allowing easy stacking and extraction bottle. each shelf You can also remove and remove, allowing stacking larger bottles. Removing the shelf 1. Remove the rack from the position STOP. 2. Lift the second shelf goods up to shelves wheels come in an extended part of the guide, then pull out the drawer.
Maintenance and cleaning Fridge not have to dissolve, because the ice to block Automatic defrost the evaporator dissolves automatically. The ice that formed on the evaporator block the action of the compressor in the period compressor standstill melt, and in the form of droplets collects in the evaporator below the aluminum body, and then through the opening in the vessel below the water to the evaporator copper pan at the bottom of the cabinet through which...
Page 15
The interior of the appliances The interior of the appliances with lukewarm water and soap or baking soda and water. Never abrasive agents, solvents, polish or undiluted detergent. Once a year it is necessary to switch off the contours of moisture, dry and soft cloth smeared environmental oil for wooden surfaces.
Page 16
Nestanak struje In case of failure or power outage, the less open the door, to keep the temperature in interior. The gradual increase in temperature will not have negative impact on the beverage. If the weather is extremely hot, you can drink move to a cooler location while waiting to turn on the electric energy.
Troubleshooting During the use of the appliance may appear less failures. Here are some of them, which often causes improper use, and you can remove yourself. Malfunction Check Make sure the plug is live and whether it is The machine does on (thermostat knob in the position of action).
Page 18
Malfunction Check Noise and murmurs Cooling in the fridge-freezers allows the cooling system with compressor and fan, and this causes a certain height noise. The severity of noise depends on the situation and the proper the use of appliances. • During operation of the compressor can be heard noise liquids, in the dormant heard streaming coolant.
Page 19
BRASS KOMERC d.o.o. Banja Luka Address: Aleja svetog Save 48 78000 Banja Luka Bosna i Hercegovina Telephone/fax: 051 257 139 E-mail: brass@teol.net UNIQUE WINE COOLER...
Need help?
Do you have a question about the 400 and is the answer not in the manual?
Questions and answers