Advertisement
Quick Links
Advertisement
Summary of Contents for Datasat 84CM
- Page 1 DataSAT 84CM Mobile VSAT System Quick Wiring and Setup Guide...
- Page 2 DataSAT ACU-1 and iDirect X5 Modem Connections There are a total of 9 connections that must be connected correctly to the DataSAT ACU-1 Satellite Antenna Controller and the iDirect X5 Modem. These connections will go to the DataSAT 84CM Antenna, Network Router, and Power Supplies included with the Antenna Controller and Modem.
- Page 3 2 - Brown – Azimuth Motor Volts – 1 - Black – Azimuth Motor Volts + Connector Box on DataSAT 84 CM Roof Mounting Plate A. Antenna Control Cable Connection. Snap together Male (33482-1201 Molex) Antenna Side and Female (33472-1201 Molex) Control Cable to ACU-1 Antenna Controller.
-
Page 4: Datasat Acu-1 Satellite Antenna Controller Setup
DataSAT ACU-1 Satellite Antenna Controller Setup Once the System is installed and wired properly the Antenna Controller is ready for setup and configuration. Turn on the ACU-1 Controller Power located on the front right side of the controller. The LCD should power on as shown below. - Page 5 If the ACU-1 HTML page does not come up you can confirm the controller IP address by using the Front Panel Menu commands. These are the Power/Menu, Search/Up, and Stow/Down buttons. Pressing the Power one time when the Controller is already on will enter the Menu Mode.
- Page 6 Move the mouse to highlight Configuration then select RF Settings. Confirm the LNB settings are correct as shown above. Any errors on this page will result in the Antenna Controller not finding the correct satellite or the Modem not getting an RX Lock. Move the mouse to highlight Configuration then select Dish Calibration.
- Page 7 Select Start. A Dish Calibration is required one time to complete installation and configuration. Once completed the System is ready for use. Press Search to begin. Controller will peak and Optimize.
- Page 8 Search Complete. System is ready for Modem Operation. End of Document.