Battery Installation - Mitsubishi LVP-X120A User Manual

Battery installation

Use two AA size batteries.
1. Remove the back cover of the remote control by pushing the battery compartment door in the direction of the
arrow.
2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).
3. Replace the back cover.
1
Important:
• Do not use a new battery with an old one.
• Load batteries in the correct position.
• Do not heat, take apart, or throw batteries into fire.
• Do not try to recharge batteries. Do not use rechargeable batteries.
• If the alkaline solution of alkaline batteries comes in contact with your skin or clothes, rinse with water. If
the solution comes in contact with your eyes, rinse them with water and then consult your doctor.
Operation area
The range for operation is about 10m when the remote control points to the projector. The distance to the screen
back to the projector must be less than 7m. Depending on the type of the screen, the distance is different.
Important:
Avoid the direct sunlight or fluorescent light to the remote control sensor. Also keep the distance of more than 2 m
between the remote control sensor and fluorescent lamp. The remote control may not work correctly.
2
20˚
15˚
30˚ 30˚
3
20˚
15˚
20˚ 20˚
9