Replacing The Spark Plug; Storing The Product; Transporting The Product - Toro 51930 Operator's Manual

Replacing the Spark Plug

See Figure 22.
Model Nos. 51930, 51932, & 51934 use a NGK
BPMR7A or Champion RCJ-6Y spark plug.
Model Nos. 51930A, 51932A, 51934A, 51936, 51938,
& 51940 use a NGK CMR7A spark plug. Use an exact
replacement and replace annually.
Follow these steps to replace the spark plug.
Remove the spark plug boot.
1.
Loosen the spark plug by turning it counterclockwise
2.
with a socket.
Remove the spark plug.
3.
Hand thread the new spark plug, turning it clock-
4.
wise.
For Model Nos. 51930, 51932: Tighten with a
5.
socket and torque to 170 in.lb. minimum, 190 in.lb.
maximum. Do not over tighten.
For Model Nos. 51930A, 51932A, 51934A, 51936,
6.
51938, & 51940: Tighten with a socket and torque
to 87 in.lb. minimum, 104 in.lb. maximum. Do not
over tighten.
CAUTION:
Be careful not to cross-thread the spark plug. Cross-
threading will seriously damage the product.
Spark Plug Boot
Maintenance

Storing the Product

Storing the product differs depending on the amount of
time it will be in storage.
Note: If the product includes another attachment, place
the storage cap on the end of the attachment shaft and
hang it up to store.
To Store the Product Short Term
Follow these steps to store the product short term.
Clean all foreign material from the product.
1.
Store the product in a well-ventilated place that is
2.
inaccessible to children.
To Store the Product Long Term
If you do not intend to use the product for more than
one month, follow the storage procedures below.
Follow these steps to store the product long term.
Drain all of the fuel from the tank into a container
1.
approved for gasoline.
Run the engine until it stops.
2.
Clean all foreign material from the product.
3.
Store the product in a well-ventilated place that is
4.
inaccessible to children.
Note: Keep the product away from corrosive agents
such as garden chemicals and de-icing salts.
Important: Abide by all federal and local regula-
tions for the safe storage and handling of gasoline.

Transporting the Product

Follow these steps to transport the product.
Drain the fuel mixture into a container that is
1.
approved for use with gasoline.
Spark
Plug
Carry the product by the front handle.
2.
Secure the product in your vehicle or on a trailer.
3.
Figure 22
23