Subscribe to Our Youtube Channel
Related Manuals for SportDOG add-a-beeper sd-ab
Summary of Contents for SportDOG add-a-beeper sd-ab
-
Page 1: Operating Guide
™ Add-A-Beeper SD-AB Operating Guide Please read this entire guide before beginning... -
Page 2: Table Of Contents
™ Thank you for choosing SportDOG Brand . Used properly, this product will help you train your dog effi ciently and safely. To ensure your satisfaction, please review this owner’s manual thoroughly. If you have questions regarding this product’s operation, please see this manual’s Frequently Asked Questions or Troubleshooting section, contact our Customer Care Center at 1-800-732-0144, or visit our website at www.sportdogbrand.com. -
Page 3: Key Defi Nitions - Add-A-Beeper
Key Defi nitions - Add-A-Beeper™ Add-A-Beeper: Receives the radio signal from the Add-A-Beeper Remote Transmitter and beeps with a tone and frequency Beeper set by the user. It is waterproof and can be submerged On/Off Speaker in water. Button On/Off Button: Turns the beeper on and off. The Add-A-Beeper functions can be disabled from the Remote Transmitter, but the Add-A-Beeper should be turned off using this button when not in use to conserve... -
Page 4: Prepare The Add-A-Beeper
™ Prepare the Add-A-Beeper Insert the Battery 1. Remove the battery cover. 2. Insert the CR-123 3-volt lithium battery with the positive (+) end facing outward. 3. Replace the battery cover. 1-800-732-0144... -
Page 5: To Turn The Add-A-Beeper On/Off
™ To Turn the Add-A-Beeper On/Off To Turn the Add-A-Beeper On: 1. Press and hold the On/Off Button until the Add-A-Beeper’s Indicator Light comes on and the Add-A-Beeper beeps 1 time. 2. Release the On/Off Button. The Add-A-Beeper’s Indicator Light will fl ash until the Add-A-Beeper is turned off. The fl... - Page 6 Beeper Indicator Light ™ Add-A-Beeper Function Indicator Light Response Add-A-Beeper On – Good Battery Flashes twice every second Add-A-Beeper On – Low Battery Flashes once every second 1-800-732-0144...
-
Page 7: Reset The Add-A-Beeper
™ Reset the Add-A-Beeper To reset the Add-A-Beeper to work with a new Remote Transmitter or to reprogram a new Add-A-Beeper to work with your existing Remote Transmitter: A. Turn the Add-A-Beeper off. B. Press and hold the On/Off Button. The Add-A-Beeper’s Indicator Light will come on, then turn off after 4-5 seconds. -
Page 8: Program The Add-A-Beeper
™ Program the Add-A-Beeper To Set the Tone: TONE 1. Reset the Add-A-Beeper Low Volume Hawk (see page 7). 2. Turn the Add-A-Beeper off. High Volume Hawk 3. Press and hold the ON/OFF Bobwhite Quail Call button. After 8 seconds, the Add-A-Beeper will start to Triple Beep emit the different tones. - Page 9 To Set the Run Mode: To program the Run Mode, press the ON/OFF button again within 2 seconds of ™ programming the Tone (see page 8). The Add-A-Beeper will emit a single beep for Mode 1, a double beep for Mode 2, and a triple beep for Mode 3. When the desired mode is heard, release the ON/OFF button.
-
Page 10: Fit The Add-A-Beeper To Your Dog
™ Fit the Add-A-Beeper to Your Dog This system is designed so you can add or remove the Add-A-Beeper to or from the collar strap as needed. To Place the Add-A-Beeper on the Collar Strap: 1. Press the green rubber saddle into the opening at the bottom of the beeper. - Page 11 To Place the Entire System on Your Dog: 1. With your dog standing, place the Collar Strap around the narrowest part of your dog’s neck. Add-A-Beeper 2. Ideally, the Collar Receiver should Location be centered at the front of the dog’s ™...
-
Page 12: Program The Add-A-Beeper To Your System: Sd-400, Sd-400S, Sd-402, Sd-800 And Sd-1800
™ Note: The Add-A-Beeper can be used on the collar strap without the Collar Receiver. To remove the Collar Receiver, simply slide the saddle and Add-A-Beeper off of the strap, and then do the same with the Collar Receiver. Replace the saddle and Add-A-Beeper. The Add-A-Beeper, without the Collar Receiver, may shift due to movement. -
Page 13: Using The Add-A-Beeper
SD-1200 ™ To use the Add-A-Beeper with your SD-1200 system, make sure the Transmitter is set to modes 4 or 7. SD-2400 To use the Add-A-Beeper with your SD-2400 system, simply press the green button. ________________________________________________________________________ Using the Add-A-Beeper In normal operating mode (Run Mode or Point Mode), if the Tone Button is pressed, the Add-A-Beeper goes into Locate Mode. -
Page 14: Frequently Asked Questions
The range you get with your Add-A-Beeper? Add-A-Beeper is up to 500 yards. This range will vary depending on which SportDOG Transmitter you pair it with. Range can also be affected by terrain, weather, vegetation, and transmission from other radio devices. -
Page 15: Troubleshooting
™ Can I use the Add-A-Beeper Yes, the Add-A-Beeper can be used by itself? independently without the Collar Receiver. However, it is recommended to have a counter weight, like the Collar Receiver, in order to keep the Add-A-Beeper on top of the dog’s neck. - Page 16 • If the Locate button (for the UplandHunter point. Remote Transmitter) or Tone button (for all other SportDOG Remote Transmitters) was pressed, then this will disable the beeper functions of the Add-A-Beeper. • To enable the beeper functions, press and release the run mode button for the UplandHunter Remote Transmitter.
- Page 17 ™ The Add-A-Beeper is not • Verify the Add-A-Beeper has been turned on. responding to the Remote Refer to “To Turn the Add-A-Beeper On/Off.” Transmitter. • Refer to “Reset the Add-A-Beeper.” • If your Remote Transmitter has a toggle switch, verify that it is in the correct position.
-
Page 18: Terms Of Use And Limitation Of Liability
Terms of Use and Limitation of Liability 1. Terms of Use This Product is offered to you conditioned upon your acceptance without modifi cation of the terms, conditions and notices contained herein. Usage of this product implies acceptance of all such terms, conditions, and notices. 2. - Page 19 3. No Unlawful or Prohibited Use This Product is designed for use with dogs only. This dog training device is not intended to harm, injure, or provoke. Using this product in a way that is not intended could result in violation of Federal, State or local laws. 4.
- Page 20 Radio Systems Corporation 10427 Electric Avenue Knoxville, TN 37932 1-800-732-0144 www.sportdogbrand.com 400-828 ©Copyright 2006, Radio Systems Corporation...
Need help?
Do you have a question about the add-a-beeper sd-ab and is the answer not in the manual?
Questions and answers