Advertisement
Quick Links
Quick Start
Instructions
I I
e:E'-
UnlSRR.
.
.nk you for purchasing the Unisar® N Listener® J3. Charge the headset for 16 hours prior to first use. For more detailed
'rnstructions, please refer to the Instruction Manual.
@
Transmitter
Infrared Rays
Charging
Adapter
Setting Up the System
Power
Switch
AC Adapter Jack
Headphone
Adapter
Connect the transmitter to your television or audio device.
Use the adapter appropriate for the type of audio output
yarn
device I
1as.
'-----"':10
audio output jacks (right and left) - Use the RCA
3.5mm stereo adapter
(D).
>
One audio output jack - Use the RCA 3.5mm mono
adapter (E).
>
Small headphone jack - Plug the transmitter directly into
your equipment.
>
Large headphone jack - Use the 6.3mm stereo headphone
adapter (F).
>
No audio output jacks - Use the microphone adapter (G).
e
Affix the microphone directly over the speaker using the
mounting piece provided.
'
©•
"' ; ;,
••
©
@
1111.
P
1
• • ....,
the AC adapter (C) into the jack marked "DC IN" on the
~,
of the transmitter and plug the adapter into an electri-
CCif
outlet.
The headset
(B)
requires two rechargeable AAA batteries
(H)
(included). To access the battery compartments, gently pull
+1.-.. ..... _ _ ,,
..-.,..,.,..,1,..
,,,...,f..f
+h..-.. h,....,...,....,i"',,....+ ,....,....,-.I
iro.c-'"'r+
,-...n,-..
r,...,-..h,....r.-.i,-..hlr.. b. A A
@Headset
Power
Indicator
Light
Power
Switch
Charging
Indicator
Volume
Control
Sensors
Charging
Light
Jack
baci< on by lining up the prongs with the corresponding
openings on the headset. Charge for 16 hours prior to first use
making sure the headset is turned off
and the transmitter is plugged in to
~a.......-11~ern1e~c~1m1i~c~arlo,......u~11e~lha-1~.d~tu~r~ne~·~d~o-1~1.--~~E
1
n~rPan~di___ALl.ABotte~
Plug the charging adapter from the
_/ _
back of the transmitter into the jack
0
marked "CHG" on the right earpiece
of the headset. The green charging
indicator light on the headset will
illuminate. Do NOT charge for more
than 24 consecutive hours as it will
shorten the life of the batteries.
Operating the System
-
Place the transmitter at or close to your eye level when you
are sitting. There should be nothing obstructing the transmission
of the infrared light rays from the transmitter to the receiver
in your headset. The transmitter must be within 33 feet
(l 0 meters) of the headset for the system to work properly.
Turn the transmitter on using the power switch on the back .
Turn the headset on using the power switch on the right
earpiece.
To prevent possible damage to your ears, be sure to lower
the volume on the headset before putting it on. Put the
headset on and adjust the volume to a comfortable listening
level using the volume control dial.
Turn the transmitter and headset off after each use except
when charging the headset when the headset should be
turned off and the transmitter should be on.
For more detailed instructions, please refer to the Instruction
Manual.
Advertisement
