Inserting Or Replacing The Batteries - Spirit CareSens N Owner's Booklet

Inserting or Replacing the
Batteries
The meter uses two 3.0 V lithium
batteries. Before using the meter, check the
battery compartment and insert batteries if
empty. When the
display while the meter is in use, the batteries
should be replaced as soon as possible. The test
results may not be saved if the batteries run out
completely.
Step 1
Make sure the meter is
turned off. Push the cover
in the direction of the
arrow to open the battery
compartment.
Step 2
Remove the used batteries
one at a time. Slip your
index finger under the
battery to lift and pull out
as shown. Insert two new
batteries with the + side
facing up and make sure the
batteries are firm in place.
12
symbol appears on the
Step 3
Place the cover on the
battery compartment.
Push down until you hear
the tab click into place.
• Note :
Removing the meter batteries will not affect
your stored results. However you may need
to reset your meter settings. See pages 20
-23.
• Note :
Batteries can be ordered free from Spirit
Healthcare call 0800 881 5423.
13