Mitsubishi PD-4225S Owner's Manual page 21

Use of the Remote Control with Other
Use of the Remote Control with Other
CABLE/DBS/DTV VCR
TV
1.
3.
DVD Player Codes
DVD/LDP brand
Mitsubishi
JVC
Panasonic
Philips
Pioneer DVD
Samsung
Sony
Toshiba
To reset to default code, enter 000
Figure 4. Programming the remote to control your DVD or LDP.
CABLE/DBS/DTV VCR
TV
1.
3.
A/V Receiver Codes
Audio brand
Mitsubishi A/V receiver
and/or CD player
Denon
Harman Kardon
JVC
Kenwood
Marantz
Onkyo
Pioneer
Sony
Technics
Yamaha
To reset to default code, enter 000
Figure 5. Programming the remote to control your A/V receiver.
IMPORTANT
If the slide switch is set to TV when you enter an A/V
receiver code, VOLUME and MUTE will control the A/V
receiver rather than the TV. To return volume and mute
control to the TV, set the slide switch to TV, press and hold
POWER and enter 000.
DVD
AUDIO
2.
Code to enter: If your
DVD
003
code is not
257
listed here,
250
please see
258, 253, 272
page 48
252
for a
261
complete
254
listing.
253
DVD
AUDIO
2.
Code to enter:
If your
010, 015, 011, 012,
audio
013, 014
code is not
234, 235, 236, 245,
listed here,
246, 359
please see
page 48
215, 223, 242
for a
233, 232
complete
208, 200
listing.
224, 350
209, 214, 240, 247
205, 207
222, 249
218, 219, 221
202, 201, 243, 244
POWER
After entering the correct codes in each position of the
remote control, use the slide switch to select which
product will respond when an operational button is
pressed. If you enter a code from the AUDIO chart while
the slide switch is set to TV, the volume and mute func-
tions change to match the A/V receiver. This is useful
when using an A/V receiver with the TV all the time. In
all other cases, only one of the below devices is allowed
for each slide switch position.
TV position:
TV
A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
POWER
LD Player
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the audio position
may be used in conjunction with select Mitsubishi CD
players. Your audio position must be programmed to
either 010 or 011. Plug the CD player power cord into a
switched outlet on the back of your A/V receiver.
Pressing the POWER button turns On the A/V receiver,
along with the CD player. In the audio position, for some
CD players, the transport controls (FF, Play, Rew, etc.)
operate the CD player.
Some manufacturers may change their products, or
they may use more than one remote control system.
If this is the case, your remote control may not be
able to operate your VCR, DVD, cable box, satellite
receiver, or A/V receiver.
A/V Products
A/V Products
IMPORTANT
Owner's Manual 21