Table of Contents Before using the V-Comb Introduction ............................pg 3 ........................ pg 4 Important Safety Information Overview ............................... pg 5 Technical Data ............................pg 6 Starting Up ............................... pg 7 V-Comb Capture Filter Installation ....................... pg 8 Operating the V-Comb ...........................
Introduction Thank you for purchasing the Licetec V-Comb. In your box, you should have the following: 1x V-Comb unit (including adaptor) 4x Disposable capture filters 1x Quick guide 1x Instruction manual 1x Cleaning brush FEATURES • Chemical-free head lice treatment •...
• Do not position the V-Comb where it will be difficult to unplug from electrical socket. • Do not use or store V-Comb in a location where it is exposed to direct sunlight, extreme heat or cold, water, lint, pet hair, dust, etc.
Overview Please read instructions before operating your V-Comb and retain for future reference. WARNING! Only V-Comb capture filters are to be used. V-Comb Parts List 1. Rounded stainless steel teeth 2. Combing angle adjustment knob 3. Combing head 4. LED illuminated filter unit 5.
-25°C to 70°C humidity RH 5% ≤ 93% (no condensation) Weight approx. 320grams Service Life of V-Comb/ approx. 5 years (1000hrs) Accessories approx. 10 years Note Disposal of this product should be carried out in accordance with the local and...
1. Check the box contents. 2. Before connecting V-Comb adaptor to power source, check that the power source electric rating is the same as the V-Comb rating and that power source is in a fully Please read instructions before operating usable condition.
V-Comb Capture Filter Installation 1. Tear open a capture filter wrapper provided in the box. 2. Securely attach capture filter to V-Comb combing head, The wrapper will contain a capture filter and a lid, keep ensuring it clips into place (until you hear a click).
Page 9
V-Comb Capture Filter Installation 3. Carefully attach the combing head, making sure not to 4. Align the guiding arrows (highlighted below) and twist to damage or crush the capture filter. lock the combing head to the main body. Now the combing head is securely locked in correct position.
Separate the hair into sections, no wider than the teeth, Two set positions are available: using hair clips. Switch on the V-Comb to begin treatment. straight position or raking position. Always start from the nape of the neck and work your way up, one section at a time, combing the top of the head last.
Page 11
Operating the V-Comb 3. Focus on one small section, no wider than the teeth, Comb through each section of hair in different at a time. Comb through each section of hair from root directions (top, bottom, left and right). Repeat this to tip ensuring you start as close as possible to the through each section several times.
Maintaining the V-Comb 1. After treatment, switch off and unplug the V-Comb 2. With the brush provided, clean any head lice and eggs from the power source. Remove the combing head that might be caught between the teeth of the comb. Fill from the main body by disassembling the unit.
Continue to comb the hair daily for at least two weeks during an infestation to ensure all lice and eggs have been eliminated. If there is an ongoing outbreak, daily treatment is essential to ensure reinfestation does not occur. To assist in preventing the problem of reinfestation thereafter, continuing to use the V-Comb twice a week is recommended. Important Treatment Summary 1.
Product Guarantee The manufacturer makes every effort to ensure that its products are manufactured without any defect. However, in the rare event of defects due to faulty workmanship or materials, we guarantee to repair or replace the product, or any part thereof, free of charge.
Additional Notes It is important that the V-Comb is configured and installed/put into service, in accordance with the instructions/guidance provided herein and is used only in the configuration as supplied. Wireless communications equipment such as wireless home network devices, mobile phones, cordless telephones and their base stations, walkietalkies may affect this equipment and should be kept at least a distance away from the V-Comb.