Sanyo VPC-HD1010BK Service Manual page 10

4. Power Supply Control
The 8-bit microprocessor controls the power supply for the overall system.
The following is a description of how the power supply is turned on and off. When the battery is attached, a regulated 3.2 V
voltage is normally input to the 8-bit microprocessor (IC301) by IC302, so that clock counting and key scanning is carried out
even when the power switch is turned off, so that the camera can start up again. When the battery is removed, the 8-bit micro-
processor operates in sleep mode using the backup lithum battery. At this time, the 8-bit microprocessor only carries out clock
counting, and waits in standby for the battery to be attached again. When a switch is operated, the 8-bit microprocessor supplies
power to the system as required.
The PON signal from the 8-bit microprocessor at pin (32) set to high, and then turns on the DC/DC converter. At this time, low
signal is output from pin (18) so that the ASIC is set to the reset condition. After, this pin set to high, and set to active condition.
When the power switch is turned off, the ASIC returns to the reset condition, all DC/DC converters are turned off and the power
supply to the whole system is halted.
Power voltage
Power OFF
Power switch ON-
CAMERA
Playback
Note) 4 MHz = Main clock operation, 32 kHz = Sub clock operation
Auto power OFF
LCD monitor
Table 5-3. Camera Mode
ASIC,
CMOS
memory
3.3 V 1.8 V 1.0 V
1.8 V (D)
OFF
OFF
OFF
OFF
ON
ON
ON
OFF
– 10 –
8 bit LCD
CPU MONITOR
3.2 V
3.3 V
(ALWAYS)
32KHz OFF
32KHz OFF
4 MHz ON
4 MHz ON