Possum QWAYO Setting Up

Setting up the
To enable the Qwayo Tablet to connect to the Wi-Fi please have the Wi-Fi Passcode available before proceeding. (Usually located on a s cker on the Router)
1)
Connect the tablet to its power supply
Insert the USB cable into the Charging Head
Insert the USB cable into the tablets
Charger / Accessory Port
2)
Turn the tablet on by
pressing and holding
the Power/ Lock Key for
3 seconds
3)
Once the splash screen has appeared swipe the
screen to unlock then wait
4)
The Qwayo so ware will start-up automa cally
as shown below
wayo for the first time (Page 1)
5)
Press the back arrow shown
to get back to the home screen as shown below
6) Press the Se ngs icon
7)
Turn on the Wi-Fi se ng (by tapping on/off switch)
8)
A er a short me a list of Wi-Fi Networks will be
shown. Press the access point you wish to connect
the tablet to
9)
If the network has a security passcode
please enter this and click connect
10)
A er a short me you should see the Wi-Fi icon
appear in the top right of the screen
11)
Once the Wi-Fi is confirmed as connected, turn
on Bluetooth (By tapping on/off switch)
12)
Remove ba ery cover on bo om of
Qwayo Hub
To remove the underside cover,
push the release latch in the direc-
on shown with the green arrow in
the picture on the le .
If the underside cover does not
pop open there is a small ledge on
the release latch that can be lev-
ered by using your fingernail to aid
the cover opening.
13)
Locate and turn On Power
Once the underside compartment
has been removed you will have
access to the On/Off switch.
Slide the switch towards the rotary
dial to turn the Qwayo Hub on.
When turning the Qwayo Hub on, the Qwayo Logo
(on the top of the Qwayo Hub) will light up green
& then flash green 5 mes.
14)
Replace Ba ery cover
Please turn to the next page Please turn to the next page Please turn to the next page Please turn to the next page