Advertisement
1EA.
SUBWOOFER ASSEMBLY
1EA.
200 WATT AMP/BRACKET ASSEMBLY
1EA.
POWER HARNESS
1EA.
OVERLAY HARNESS
2EA.
T-TAP
1EA.
10MM BOLT
1EA.
FUSE 30 AMP
6EA.
WIRE TIES
1EA.
INSTRUCTIONS
1. Gently pull out on the panel just below the steering column, rotate down and remove. Fig. 1
2. Remove the two 7mm screws securing the plastic panel below the steering column indicated by the
arrow in Fig. 2, and the one 7mm screw near the kick panel. Also, remove the two 10mm bolts
securing the metal plate and remove plate.
77KCK051
Audio System Upgrade Package
2011-UP Jeep Wrangler 2-Door
10" Subwoofer Kit
Installation Instructions
Fig. 1
© 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
CONTENTS
TOOLS REQUIRED:
Ratchet
13mm Socket
10mm Socket
Phillips Screwdriver
Pliers
Panel Removal Tool
Amp Installation
6-3-2011
P/N
RUWRANGLER
P/N
RM11JKBTL - Bracket
P/N
RE08BTL200R - Amp
P/N
RHWRANGLERPWR
P/N
RHWRANGLER
P/N
RFTTAPB
P/N
RFM6
P/N
RFUSE30
P/N
RFZIP6
P/N
RBI77KCK051
Fig. 2
Page 1 of 6
Advertisement
Table of Contents
Summary of Contents for Mopar 2011-UP
- Page 1 Fig. 2, and the one 7mm screw near the kick panel. Also, remove the two 10mm bolts securing the metal plate and remove plate. Fig. 1 Fig. 2 77KCK051 6-3-2011 Page 1 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
- Page 2 6. Reinstall the metal plate over the top of the amp bracket and replace the factory bolts and tighten. 7. Tighten the bottom bolt. Fig. 5 77KCK051 6-3-2011 Page 2 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
- Page 3 15. Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it. Fig. 8 Fig. 9 77KCK051 6-3-2011 Page 3 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
- Page 4 23. Connect the green wire of the subwoofer harness to the gray/brown strip wire. Connect the brown wire of the subwoofer harness to the green/brown stripe wire. Fig. 10 77KCK051 6-3-2011 Page 4 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
- Page 5 30. To remove the subwoofer press the tabs on each side of the mounting bracket while lifting up. Disconnect wiring. Fig. 14 Fig. 13 Fig. 14 77KCK051 6-3-2011 Page 5 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
- Page 6 31. Reinstall all previously removed parts in reverse order. 32. Install supplied fuse in the fuse holder under hood. 77KCK051 6-3-2011 Page 6 of 6 © 2011, Chrysler, LLC. Mopar is a registered trademark of Chrysler, LLC. All rights reserved.
Need help?
Do you have a question about the 2011-UP and is the answer not in the manual?
Questions and answers