Recording Performances - Roland F-140R Owner's Manual

Operation Guide

Recording Performances

You can record your performance, including accompaniment.
You can play back a recorded performance to check your playing, or to play along with
it.
Getting Ready to Record
1 .
Select the tone that you want to play on the keyboard (p. 2).
2 .
Start the metronome if desired.
Press the [Metronome] button.
While the metronome is sounding, specify the tempo and time signature of
the song (p. 3).
If you want rhythm to play
3 .
If you want a rhythm accompaniment to be heard while you
perform, press the [Rhythm] button.
Specify the rhythm and tempo settings (p. 5).
If you don't want rhythm to play
3 .
Press the [Song] button so the button is lit.
Entering Recording-standby Mode
4 .
Hold down the [Song] button and press the [Rhythm] button.
The [Song] button and the [Rhythm] button will light; the unit will enter
recording-standby mode.
MEMO
If you decide not to record (i.e., if you want to exit recording-standby
mode), hold down the [Song] button once again and press the [Rhythm]
button.
Starting Recording
5 .
Press the [s] button.
A two-measure count will sound, and then recording will start.
During the count, measure numbers " -2 " and then " -1 " will appear in the
display.
MEMO
Recording will start automatically if you play the keyboard while in
recording-standby mode.
If you want to erase the recorded song
You can erase a song by recording an empty song as follows.
1 .
Press the [Song] button.
2 .
Hold down the [Song] button and press the [Rhythm] button.
3 .
Press the [s] button to hear the two-measure count, and then press the [s] button without playing the keyboard.
4 .
Select the song number that you want to erase, and press the [Metronome] button.
A song containing no notes will be recorded; the song has been erased.
6
Stopping Recording
6 .
Press the [s] button.
By pressing the [s] button once again, you can hear the song that you
just recorded.
Selecting the Destination of the Save
7 .
Use the [-] [+] buttons to select the destination at which to save,
and then press the [Metronome] button.
U (User) U.01 – U.10
N (USB) N.01 – N.gg
A song with no recorded data (empty song)
v01
• Song number shown with lowercase " v " (User memory)
• Song number shown with lowercase " n " (USB flash drive)
• No dot shown
A song with recorded data
U.01
• Song number shown with uppercase " U " (User memory)
• Song number shown with uppercase " N "
(USB flash drive)
• Dot shown
MEMO
If you decide not to carry out the save, hold down the [Song] button and
press the [Rhythm] button to cancel it.
NOTE
If you select a song that already contains data (song number with an
uppercase " U " or " N ") and save, the previously recorded data will be
lost .
* While the song is being saved, an animation of a rotating " o " symbol
will appear in the display for several seconds. Do not turn off the
power during this time . Doing so might cause the saved song to
be lost .