Trouble-Shooting; Dvb-T Part - Nevir NVR-2758DVD-PTUB Instruction Manual

Trouble-shooting

Carry out the problem-solving measures described in the following section before
contacting Customer Support.
Turn off the DVD player immediately as soon as you suspect a malfunction.
Unplug the power plug and check whether the DVD player is unusually warm or
whether smoke is rising from it.
Problem
Possible cause
Disc cover not closed
The DVD player
No disc inserted
does not work
Disc inserted the wrong way
Disc dirty or deformed
Regional code of the player does not
match the regional code of the DVD
Moisture on lens
No audio Device not properly connected
Headphones connected
(loudspeaker off)
DVD sound settings incorrect
Disc dirty or deformed
No video TV screen is off or in the incorrect
video mode
Device not properly connected Check connexions and connect device in
Disc dirty or deformed
Poor video and/or
audio quality
Loop mode is switched on
Repeated
playback of a Disc dirty or deformed
section
Obstacle between remote control
Remote control
and DVD player
does not work
Remote control not pointed at DVD
player
Remote control battery inserted the
wrong way
Battery too low or completely
discharged
8
Remedy
Close disc cover
Insert disc
Insert disc with label facing up
Clean disc, or insert other disc
Purchase DVD with corresponding
regional code
Remove disc and turn off
DVD player for at
least two hours
Check connexions and
connect device in the correct way
Pull out the headphones
Check sound settings and set sound
correctly
Clean disc, or insert other disc
Turn on LCD screen and/or set correct
video mode
the correct way
Clean disc, or insert other disc
Exit the loop mode
Clean disc, or insert other disc
Remove obstacle
Point remote control directly at DVD player
Check the battery's polarity and, if
necessary, insert battery correctly
Insert new battery

DVB-T PART

1. First Time Installation
If you are using the receiver for the first time, a First Time Installation menu will
be displayed to guide you through the initial setup. Use the remote controller to
finish the setup.
Init Install
OSD Language : English
Area : Germany
Time Zone : GMT+1
FTA Default setting
A. At the First time installation menu,
include your Language,Country, TimeZone .
B. Then Select <ENTER> to start the automatic channel search.
C. Wait to complete the scanning.In case you want to stop the scanning,
press the <EXIT> button. The channels already found will still be stored.
D. When finished, all active channels found will be stored automatically.
The last found channel will be played.
E. If you want to reset your regional settings and clear all the
you can select<FTA Default Setting>and confirm to reset it.
2. DVB Mode of Main Menu
Press the <SETUP> or <MENU>button, the DVB main setup menu appears
the screen, then press the <DOWN> button to highlight the DVB Menu option.
Installation
Auto search
Manual Search
System setup
English
Fraccais
Espanol
Deutsch
Nederlands
Polski
You can select your regional settings,
stored channel ,