Catalina Cat 200 - Catalina Saber Owner's Manual

Catalina CAT200 Topside Controller
Don't Panic! No Programming is Necessary!
Initial Start-up
When your spa is first activated, it begins running in "Economy" mode. This setting
is designed for periods of little or no spa use, but the spa continues to filter twice a
day to maintain water quality. Press the button to switch the spa to "Standard"
mode and your spa will automatically heat and maintain the water temperature at
the desired program setting. The factory default temperature setting is 100°F.
Setting the Time of Day
When your spa is first powered up, the words "SET TIME" will flash on the display.
To set the time, press , then or . After or is
pressed once,the time will begin changing in one-minute increments. Press either
pad to stop the time from advancing. Press to enter the time into the system.
Water Temperature Adjustment
The water temperature can be adjusted from 80°F - 104°F. Press either or
to increase or decrease the water temperature. After three seconds, the LCD
will display the current spa temperature.
Optional Filter Cycle Programming
Your spa will automatically filter itself twice a day. The low speed of the pump and
ozone generator (if equipped) will run the duration of each filter cycle.
While you are not required to set filter cycles, you can make changes anytime by
pressing within 3 seconds. "SET START FILTER 1" (a.m. cycle)
will appear on the display. Press or to reset the filter start time.
When "SET HEAT" appears on the display, press to warm the water during
the filter cycle or to disable the heater.
Press to see "SET STOP FILTER 1" and adjust the time in the same manner
as above.
Press to see "SET START FILTER 2" and proceed as above. Pressing
will enter the new cycle times and display the current water temperature.
18