Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for steel Genesi GK120
Summary of Contents for steel Genesi GK120
- Page 1 INSTRUCTION MANUAL Exhaust / recirculating hood...
-
Page 3: Table Of Contents
CLEANING OF THE HOOD ..................14 Charcoal filters....................... 14 Metal grease-trapping filters .................. 14 Cleaning the stainless steel surfaces ..............14 Cleaning the polished surfaces ................14 Cleaning the inside of the appliance..............14 Cleaning the control panel ..................14 LAMP REPLACEMENT .................... - Page 4 2 General informations Thank you for choosing this Symbols used product..dedicated to real lovers of cooking. Important note. Failure to comply may cause Our goal has always been to promote a culture danger that may jeopardise the user's health and of good taste, attention to detail, and a refined, the integrity of the equipment.
-
Page 5: General Safety Guidelines
Warnings 3 General safety guidelines Electrical safety • DO NOT LEAVE PACKING RESIDUE UNATTENDED AROUND • THE APPLIANCE MUST BE INSTALLED BY QUALIFIED THE HOME. PERSONNEL, IN ACCORDANCE WITH THE STANDARDS IN FORCE. IF THE SUPPLY CORD IS DAMAGED, IT MUST BE •... -
Page 6: Proper Use
4 Warnings Proper use Reference standards • THE APPLIANCE IS DESIGNED TO BE USED BY ADULTS ONLY. • THIS PRODUCT CONFORMS TO THE REQUIREMENTS OF THE DO NOT ALLOW CHILDREN TO APPROACH THE APPLIANCE OR FOLLOWING EUROPEAN DIRECTIVES: USE IT AS A TOY. •... -
Page 7: Components
Installation 5 Components The packing contains the following components: • an extraction/filtration hood; • a chimney complete with extension; • one or two wall mounting bars, depending on hood type; • two or four 8 mm toggle bolts with screws, depending on hood type;... -
Page 8: Dimensions
6 Installation Dimensions Type K 700 / 900 / 1000 / 1172 Type GK 700 / 900 / 1000 / 1200 Type AK 700 / 900 / 1000 / 1200... -
Page 9: Assembly
Installation 7 Assembly At horizontal sections, the pipe must be slightly tilted Minimum distance from cooktop upwards (about +10%) to allow the extracted air to exit The minimum distance between the gas cooktop and more easily. the bottom of the hood must be at least 750 mm. If the Keep the number of bends to a minimum and check that gas cooktop manual specifies a greater distance, this pipes are the minimum essential length. -
Page 10: Removing The Chimney From The Hood (Gk And Ak Hoods Only)
8 Installation Removing the chimney from the hood (GK and AK hoods only) Fig.1 In "type K" hoods, the chimney is packed next to the hood; in "type GK" hoods, the chimney is secured in the interior compartment and turned 90°... -
Page 11: Hood Assembly
Installation 9 Hood assembly • Rest the mounting bar "A" against the wall, at a height determined by the sum of the 750 mm distance from the cooktop + the "h" value relating to the relevant model of hood. • "Type K" hood: h = 520 mm •... -
Page 12: Chimney Assembly
10 Installation Chimney assembly Refitting the metallic filters • Move part "G" towards the hood until fully inserted. Reposition the filters by introducing first the guides "P" • Screw part "G" to the hood using the self-tapping into the rear slots, then push the filters up and lock them screws "N". -
Page 13: Electrical Connections
Installation 11 Electrical connections Test Check: • that the duct and external outlet are not blocked; • the metallic and active charcoal filters (if fitted) are positioned correctly. Refer to section “Active charcoal The connections must be performed in filters” on p. 16. compliance with the legal standards in force. -
Page 14: Operation
12 Use Operation Intensive operation On pressing the increase button three times, the hood enters intensive operation mode (the button flashes). Intensive operation is timed and the motor returns Electronic control panel automatically to the 3 speed after about 15 minutes. The hood has three different suction speeds plus one for intensive operation. -
Page 15: Tips
Use 13 Tips FIRST SPEED (decrease button lit): to maintain clean air in the kitchen with low electric consumption. SECOND SPEED (decrease and on/off buttons lit): for normal cooking. THIRD SPEED (decrease, on/off and increase buttons lit): to eliminate strong odours and steam from the kitchen. -
Page 16: Cleaning Of The Hood
Regular maintenance ensures the hood will run Pour the solution onto a damp cloth and wipe the steel efficiently over time. Particular attention should be paid surface, in the direction of the satin finish, rinse to the metallic and active charcoal filters. -
Page 17: Lamp Replacement
Special maintenance 15 Lamp replacement Make sure the appliance is disconnected from the mains power supply. Light bulbs with different shapes and power ratings from the original may seriously damage the light compartment. • Remove, by levering with a screwdriver, the support ring “A”... -
Page 18: Accessories On Request
"C" in nut "F". Coloured edge (type GK hoods only) • Reposition the metallic filters. Front moulding in painted steel available in a variety of colours. • Remove the metallic filters "A". • Unscrew the ten screws "B" from inside the hood. -
Page 19: Troubleshooting
Troubleshooting 17 Troubleshooting If the equipment is not working properly, consult the If the cause of the problem cannot be found, following table of possible causes and recommended switch off the equipment, remove the plug and remedies before contacting Customer Service. contact Customer Service. - Page 20 B00090 ZS5077 08/14...
Need help?
Do you have a question about the Genesi GK120 and is the answer not in the manual?
Questions and answers