Table of Contents
Advertisement
26.
THIS MACHINE IS NOT MEANT FOR
HIGHWAY OR STREET USE. It is not
a recreational vehicle and it should not
be operated as such.
27.
ALWAYS DISENGAGE THE MOWER
BLADE CLUTCH when transporting.
SAFETY INTERLOCK SYSTEMS
Your Country Clipper Zero Turning Radius
Mower is equipped with switches interlocked for
your safety.
ON JOYSTICK MODELS
"DOWN"
JOYSTICK IS IN THE
ON TWIN STICK MODELS
BOTH HANDLES ARE IN THE
1.
The mower blades must be disengaged
before engine will start.
2.
The Control Lever(s) must be in the
neutral position before the engine will
start.
3.
The engine will stop if the mower blade
clutch is engaged when the operator
leaves the driver's seat.
4.
The engine will stop if the Control
Lever(s) are not in the neutral position
when the operator leaves the driver's
seat.
5.
The engine will stop if the brake is
"SET" and the Control Lever(s) are not
in the neutral position.
6.
The engine will stop if the brake is
"SET" and the mower blade clutch is
engaged.
DO NOT OPERATE MOWER IF SAFETY
SWITCHES ARE NOT OPERATING
PROPERLY
START UP AND OPERATION
CHECKLIST BEFORE OPERATION
1. Make sure fuel tank is full. Use regular
unleaded gasoline (see engine owner's
manual for more details).
NEUTRAL IS WHEN THE
POSITION.
NEUTRAL IS WHEN
"OUT"
POSITION.
WARNING
HANDLE GASOLINE WITH CARE -- IT IS
HIGHLY FLAMMABLE. DO NOT SMOKE.
ENGINE SHOULD BE OFF AND COOL. USE
APPROVED GAS CONTAINER. NEVER FILL
TANK INDOORS. WIPE UP ANY SPILLS.
REPLACE CAP TIGHTLY.
2.
Make sure dirt and foreign matter is kept
out of gas tank. Use a clean funnel and
gas can.
3.
Do not mix oil with gasoline.
4.
Do not use white, high test or premium
gasoline. Do not use de-icers,
carburetor cleaners, or other such
additives.
5.
Check the crankcase oil level. Make
sure the engine is off. The mower
should be parked on a level area. Do
not overfill. (See your engine manual for
more detailed instruction.)
6.
Check the hydrostatic transmission oil
level. (See "Maintenance" section of this
manual.)
7.
Check battery fluid level.
8.
Inspect V-belts.
9.
Check tire pressure:
Model
Front tires
All
Models
10.
Make sure underside of mower deck is
free of grass.
11.
Make sure mower blades are sharp and
secured tightly.
12.
Clean the air intake screen on the
engine if necessary.
13.
Perform any other maintenance as it
becomes necessary. (See the
"Maintenance" section of this manual.)
IMPORTANT: Before cutting grass, clutch must
be broken-in as follows: With engine at
full RPM engage deck until blades come
to full speed and then disengage until
blades come to a complete stop.
Repeat 10 times to seat clutch properly.
5
Rear tires
12 psi
12 psi
Advertisement
Table of Contents
