Streamline 300GPD-F Installation Instructions

Ro filtration system

This 300 GPD filtration system is very efficient at reducing water hardness and is simple to install and

maintain.

It is the installer's responsibility to ensure that this appliance is plumbed in accordance with local authority's

bye-law regulations.

INSTALLATION INSTRUCTIONS

Unscrew the three vertical filter bowls and remove the wrapping from the cartridges and reassemble.

A filter spanner is included in the kit for loosening the filter bowls. Do not over tighten filter bowls

when re-assembling.

Alternatively a Hozelock type connection kit can be purchased to simplify the hose connection. (part

no. KIT 01300 Brass fittings kit or KIT01301 Nylon fittings kit)

main pure water collection tank. (See Fig 2)

300GPD-F RO FILTRATION SYSTEM

The white nylon hosetail elbow (optional kit- part no. KIT01302)

allows you to connect standard 1/2" (12mm) hose to the INLET of

the third vertical filter housing. Remove the existing elbow and

simply screw this fitting into the filter. Connect the water supply

hose to this fitting and tighten it on with a jubilee clamp. Connect

Inlet Connection

Cut and connect a suitable length of ¼" tube to the waste

RO Inlet Connection

Pure Water Connection

Waste Water Connection

tube to the joiner from the kit and connect to the white tube

coming from the shut off valve. This must discharge into the

Page 1 of 3

the inlet hose to the mains water

supply.(See Fig 1)

water connection which is marked

DRAIN. This tube is the waste water

tube and must discharge into the

nearest suitable drain. Cut and

connect a suitable length of ¼"

Table of Contents

Need help?

Do you have a question about the 300GPD-F and is the answer not in the manual?

Page 1 300GPD-F RO FILTRATION SYSTEM This 300 GPD filtration system is very efficient at reducing water hardness and is simple to install and maintain. It is the installer’s responsibility to ensure that this appliance is plumbed in accordance with local authority’s bye-law regulations.
Page 2 Temporarily remove the small white tube on inlet connection of the RO housing filter housing(See Fig 2), and turn the water supply on, allowing the water to flush through the first three vertical filters for 2-3 minutes, until all visible impurities have disappeared. Turn the water supply off. Identify the small RO plug which is packaged in the RO membrane bag.
Page 3 CHARGES, THE COST OF RETURNING DEFECTIVE PARTS TO VARITECH. This warranty constitutes the exclusive remedy of any purchaser of a STREAMLINE unit and is in lieu of all other warranties, express or implied, including without limitation any implied warranty of merchantability or fitness for use, to the fullest extent permitted by law.