Aqua Logic DS-4-WCMD Installation And Maintenance Manual

Aqua Logic DS-4-WCMD Installation And Maintenance Manual

Delta star water-cooled marine duty in-line water chillers
Hello, I am your AI assistant. How can I help you?

Advertisement

Aqua Logic, Inc.
9558 Camino Ruiz.
San Diego, CA 92126
PH: 858.292.4773 Fax: 858.292.0537
Email: info@aqualogicinc.com
Website: www.aqualogicinc.com
__________________________________________________________________________________________
Installation and Maintenance Manual
For
Delta Star Water-cooled Marine Duty
In-Line Water Chillers
(Models DS-4-WCMD thru DS-10-WCMD)
DS-9-WCMD shown
Use Quick Install page for easy setup
.
Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the DS-4-WCMD and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Aqua Logic DS-4-WCMD

  • Page 1 PH: 858.292.4773 Fax: 858.292.0537 Email: info@aqualogicinc.com Website: www.aqualogicinc.com __________________________________________________________________________________________ Installation and Maintenance Manual Delta Star Water-cooled Marine Duty In-Line Water Chillers (Models DS-4-WCMD thru DS-10-WCMD) DS-9-WCMD shown Use Quick Install page for easy setup Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016...
  • Page 2 You can call us or visit us on the web for technical assistance before and after the sale. We are committed to making sure that you are satisfied with your Aqua Logic Chiller now—and in the future.
  • Page 3: Delta Star Plumbing

    • We highly recommend that you use a ground-fault interrupter (GFI) to avoid electrical shock. You can obtain an inline GFI from Aqua Logic, a local hardware store if the outlet in the wall does not have a GFI installed.
  • Page 4 Regulate condenser water until pressure on the pressure gauge reads between 115 to 125 PSIG for models DS-4-WCMD thru DS-9-WCMD and 195 to 220 PSIG for model DS-10-WCMD. Check after 15 minutes of run time, adjust the water flow (if needed) to the correct pressure.
  • Page 5: Chiller Control Programming

    CL - Appears if calibration mode has been entered. To correct: Remove power to the control for least five seconds. Reapply power. If the CL message still appears, replace the control Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016...
  • Page 6 Chiller—especially a ½-HP unit needed on a 300-gallon tank. It is very unfortunate when equipment fails. However, a prudent aquarist should have a disaster plan and follow the motto, “Be prepared.” Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016...
  • Page 7: Maintenance And Cleaning

    Allow the heat exchanger to dry and then return the Chiller to service. NOTES: If you have any questions or concerns about maintaining your Aqua Logic Chiller, please call us at (858) 292-4773. Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016...
  • Page 8: Specifications

    31 x 26 x 19 The condenser seawater flow rate is based on 55-60 °F entering water temperature. The condenser head pressure is maintained by metering the water flow via gate valve. Copyright© 2016 Aqua Logic, Inc. Effective date of 1/2016...
  • Page 9: One-Year Limited Warranty

    • Once Aqua Logic determines that the defect is due to parts or workmanship and that the product is under warranty, Aqua Logic will repair or replace the product solely at their discretion. Our warranty does not cover the following: •...

This manual is also suitable for:

Ds-10-wcmd

Table of Contents