Page 3
Your hearing aid ear drum of the hearing-impaired person. expert will also supply you with information on Your hearing system is suitable for compensating regular maintenance measures.
Page 4
132 dBSPL. Particular care must • Commissioning of apollon be taken when adjusting the device as there is a risk • Fitting - Programming of apollon of damage to the user´s residual hearing. Instruction during the use of the aid...
Page 5
Instructions before use of the aid Parts of the aid Volume control O-T-MT-M mode control switch Low battery warning LED Battery compartment Paediatric lock ( Technical data according IEC 60118-0 Line-In (3,5 mm) Max. output (dBSPL) Max. gain (dB) Shirt-clip Current consumption (mA) 13,2 + - 10 % @ 3 V Receiver cable...
Commissioning of apollon Your ENT specialist or acoustician will instruct you in detail about the handling of the hearing system and about the accessories. TO ENSURE SAFETY AND FUNCTIONALITY OF THE HEARING SYSTEM USE ONLY ACCESSORIES APPROVED BY BHM-TECH. Cable - connections Fig.1...
In case of unpleasant comfort or skin irritation contact your ENT specialist or acoustician immediately. Fitting – Programming of apollon Fig.3a (For the ENT specialist or acoustician only!) Important information:...
Page 8
Attention: Ensure that the cable is connected the software and the equipment approved by proper according the markings on the cable plugs BHM-Tech. and according the markings on the sockets on the aid and on the programming interface 3. Post programming (see fig.
Insertion of the batteries Fig.5 The apollon is equipped with a paediatric lock for the battery compartment. By sliding the red knob (5) to the right - the battery compartment (4) is locked; sliding to the left the battery compartment is unlocked (see fig.
Page 10
Fig.10 Fig.7 open locked Fig.8 Low battery warning LED Fig.9 Fig.11...
Volume control Hint: Before switching on the aid, changing the With the volume control (1) (see fig. 12) you can modes, or connecting external devices to the aid, adjust the volume for your convenience. always turn the volume control to 1 (lowest volume). Adjusting range: 1 …...
Mode Control Switch Switching on apollon is equipped with a 4 position O-T-MT-M After switching on the aid, the battery-status will be checked and the LED-lamp (3) lights up and goes off switch (2) (see fig.13). when the batteries are in good condition.
DAI (Direct Audio Input) signals. The apollon is equipped with a DAI (6) which is Telecoil mode placed on top of the aid beside the microphone port. Switching to the “T” position, the input signal from...
Page 14
In case an external accessory device is connected to external audio input or DAI, the hearing device apollon switch automatically to Line-In or DAI-mode. A beneficial use in the same time of audio Input and DAI-Input is not possible! In case of trying to use both external inputs, the external audio Input will be automatically preferred.
Page 15
Shirt-clip: apollon is equipped with a shirt-clip (8). Your acoustician or ENT specialist will advise you about the The batteries of apollon have to be replaced as soon wearing opportunities with this shirt-clip. as the optical battery warning lights up.
Use of DAI 4-times high peep tone relevant shops. Never use any chemical detergents, water, cleaning fluids or oil to clean the apollon. Use of ext. audio input (Line-In) 5-times high peep tone Dispose of apollon and batteries...
Input of apollon has to comply with t h e s a f e t y r e q u i r e m e n t s o f E N 6 0 6 0 1 o r The hearing system apollon is able to transmit EN 60065.
Page 20
EC-Directive 93/42 EEC Quality certificate according to DIN EN ISO 13485 0297 BHM-Tech Produktionsgesellschaft mbH Grafenschachen 242 7423 Grafenschachen, Austria www.bhm-tech.at Made in Austria +60°C -20°C Content may be changed without notice in order to improve product performance.
Need help?
Do you have a question about the Apollon and is the answer not in the manual?
Questions and answers