Emhart POP PB2500 Manual
  1. Manuals
  2. Brands
  3. Emhart Manuals
  4. Power Tool
  5. POP PB2500
  6. Manual

Emhart POP PB2500 Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

English
PB2500
Battery tool
for blind rivets
www.emhart.com
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POP PB2500 and is the answer not in the manual?

Questions and answers

Summary of Contents for Emhart POP PB2500

  • Page 1 English PB2500 Battery tool for blind rivets www.emhart.com...
  • Page 2 (electronically or mechanically) without prior explicit and written permission from Emhart Teknologies . The information provided is based on the data known at the moment of the introduction of this product. Emhart Teknologies pursues a policy of continuous product improvement and therefore the products may be subject to change.
  • Page 3 English Fig. 1 3.2 [1/8] [3/32] [1/8] 4,8 [3/16] [5/32] [3/16] 4.0 [5/32] Fig. 2 Fig. 3...
  • Page 4 English Fig. 4 Fig. 5 Fig. 7 Fig. 6 Fig.8 Fig. 10 Fig. 9...

  • Page 5: Table Of Contents

    English CONTENT Technical Data................................EC-Declatation of Conformity..........................Defenitions: Safety Guidelines..........................General Power Tool Safety Warnings........................Additional Specific Safety Rules for Blind rivet tools..................Residual Risks................................Markings on Tool............................... Important Safety Instructions for All Battery Chargers................Chargers..................................Chargers Procedures..............................Charging Process............................... Hot/Cold Pack Delay..............................

  • Page 6: Technical Data

    English BATTERY TOOL for BLIND The vibration emission level given in this information sheet has been measured in accordance with a RIVETS standardised test given in EN 60745 and may be used to compare one tool with another. It may be used for a preliminary assessment of exposure.

  • Page 7: Ec-Declatation Of Conformity

    English...

  • Page 8: Defenitions: Safety Guidelines

    English Keep children and bystanders away while Fuses operating a power tool. Distractions can Europe 230 V tools 10 Amperes, mains cause you to lose control. 3. Definitions: Safety Guidelines 4.2) ELECTRICAL SAFETY The definitions below describe the level of severity Power tool plugs must match the outlet.
  • Page 9 English 4.3) PERSONAL SAFETY Maintain power tools. Check for misalignment Stay alert, watch what you are doing and use or binding of moving parts, breakage of parts common sense when operating a power tool. and any other condition that may affect the Do not use a power tool while you are tired or power tool’s operation.

  • Page 10: Additional Specific Safety Rules For Blind Rivet Tools

    English 4.6) SERVICE Before using the charger, read all instructions  Have your power tool serviced by a qualified and cautionary markings on charger, battery pack and product using the battery pack repair person using only identical replacement parts. This will ensure that the safety of the power WARNING: Shock hazard.

  • Page 11: Chargers

    This feature ensures maximum battery life. The EBCB105 charger accepts EBC181 & Emhart Li-Ion tools are designed with an Electronic EBC180, 18 V Li-Ion battery packs. Protection System that will protect the battery against overloading, overheating or deep discharge.

  • Page 12: Battery Packs

    English READ ALL INSTRUCTIONS into the eye, rinse water over the open eye for 15 minutes or until irritation ceases. If medical Do not charge or use the battery pack attention is needed, the battery electrolyte  in explosive atmospheres, such as in the is composed of a mixture of liquid organic presence of flammable liquids, gases or carbonates and lithium salts.

  • Page 13: Package Contents

    English 18. Description (fig. 1) Problem powerline. WARNING: Never modify the power Do not probe with conductive objects. tool or any part of it. Damage or personal injury could result. Do not charge damaged battery packs. Components Components Use only with POP® battery packs. Fig.

  • Page 14: Electrical Safety

    English 20. Electrical Safery 23. Inserting and Removing the The electric motor has been designed for one Battery Pack from the Tool (fig. 3) voltage only. Always check that the battery pack voltage corresponds to the voltage on the rating NOTE: For best results, make sure your battery plate.

  • Page 15: Tool Setup & Mandrel Collection

    English 26. Tool Setup & Mandrel Collection If you release the switch (J) before the end • of the setting stroke, the tool will WARNING: Before adjusting tool, always immediately return to its initial position. remove the battery pack. If the blind rivet (Y) has not been set completely, repeat the previous steps.

  • Page 16: Cleaning

    English 29. Cleaning Cleaning the Nose Housing & Jaw Case (fig. 4 & 5) • Loosen the nose housing nut (C). Remove WARNING: Blow dirt and dust out of the nose housing (B). the main housing with dry air as often as •...

  • Page 17: Protecting The Environment

    POP® office at the address indicated in this installation, maintenance, alteration or modification manual. Alternatively, a list of authorised POP® in any way by anyone other than Emhart Teknologies, repair agents and full details of our after-sales or its authorized service centers, are excluded from service and contacts are available on the Internet at: www.emhart.com...

  • Page 18: Spare Parts - Optional Equipment

    English 34. Spare Parts - Tool Int´l Part No. Despription Fig. reference TP124-542 SA Nosepiece, 6 Size (4,8mm -1/16 “) Fig.1. item A PRS2500-01 Jaw Guide Fig. 5. item R 13300 Jaws - One Set (3) Fig. 5. item S TP124-549 SA Jaw Pusher, 6 Fig.
  • Page 19 English Europe Americas Asia The Netherlands Norway USA - Connecticut China Emhart Teknologies B.V. Emhart Teknologies Emhart Teknologies Emhart Teknologies P.O. Box 70 Emhart Sjong 4 Corporate Drive, Suite 395 Shanghai Emhart Fastening 6120 AB Born PO Box 203 Shelton, CT 06484...
  • Page 20 English DC with manual in all European languages Only for QW sets sold in Europe...

  • Page 21: Hints For Quick Use

    English 35. Hints for Quick use Mount the nose piece (A). Close the lid (E) of the mandrel Place the blind rivet (Y) in the nose collector (X). piece (A) • If the blind rivet (Y) has not been set completely, repeat the previous steps.

Table of Contents