Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Geneko GWG-30
Summary of Contents for Geneko GWG-30
-
Page 1: Quick Start
QUICK START G U I D E GWG Gateway GWG-30, GWG-40... -
Page 2: What's In The Box
WHAT’S IN THE BOX: 1. GWG Gateway 2. Power supply cord (AC/DC adapter - optional) 3. Antenna GSM/UMTS (850/900/1800/1900/2100MHz) - Page 3 PORTS & CONNECTORS RS-232 RS-485 ETHERNET CONNECTOR CONNECTOR CONNECTOR CONNECTOR The front panel of GWG-30 GWG Gateway MAIN GSM/UMTS GPIO POWER ANTENNA CONNECTOR CONNECTOR CONNECTOR The rear panel of GWG-30 GWG Gateway RESET BUTTON...
-
Page 4: Inserting Sim Card
INSERTING SIM CARD Warning: do not insert or eject SIM card while the GWG Gateway is powered on. Make sure to disconnect the GWG Gateway from AC/DC adapter before inserting or ejecting SIM card. * Use a screwdriver to remove the cover from the back of the GWG Gateway * UNLOCK SIM card holder * Lift the SIM card HOLDER and put SIM card in it * LOCK SIM card holder... - Page 5 CONNECTING GWG GATEWAY * Connect antenna to the GWG Gateway. Make sure to tighten antenna in order not to be loose causing signal disruption. * Plug AC/DC adapter cable into POWER CONNECTOR on the GWG Gateway. RED wire - POWER (9-36VDC); BLACK wire - GROUND; GREEN wire - GPIO output;...
-
Page 6: Administration Web Page
ADMINISTRATION WEB PAGE Add network 192.168.1.0/24 to the interface on your PC * Optional: Ping 192.168.1.1 to check if the GWG Gateway is reachable * Open your Web browser (e.g. Firefox, Chrome, Safari, Opera, or Internet Explorer) and enter the following address: http://192.168.1.1 * When prompted for your login credentials, use "admin"... -
Page 7: Quick Setup
QUICK SETUP * Once logged in to administration web page, click on SETTINGS > MOBILE SETTINGS link from the menu on the left side of the screen. * If SIM card is present, ENABLED check box will be checked. Otherwise, you need to insert SIM card as explained in "Inserting SIM cards"... -
Page 8: Turn Logging On
When troubleshooting GWG Gateway make sure logs are turned on and log size is set to 512 KB or 1 MB. You should send logs to Geneko when submitting support request. * Click on MANAGEMENT > LOGS link from the menu on the left side of the screen.
Need help?
Do you have a question about the GWG-30 and is the answer not in the manual?
Questions and answers