Advertisement

Owner's & Operator's Manual
SGM Industries, LLC
It is imperative for your safety that you read and understand these instructions before
operating the TB 220
Industries, LLC at the address below. Keep these instructions in a convenient place for
future reference.
TM
TB 220
Turf Brush Owner's Manual Rev D
TM
Turf Brush. If you have any questions please contact SGM
SGM Industries, LLC
1875 Ridgemont Court
Montgomery, IL 60538
Phone: 630.688.5192
jeff.scott@sgmindustries.com
sgmindustries.com
Copyright 2015 SGM Industries, LLC
TM
TB 220
Turf Brush
Page 1 of 11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TB 220 Turf Brush and is the answer not in the manual?

Questions and answers

Summary of Contents for SGM TB 220 Turf Brush

  • Page 1 It is imperative for your safety that you read and understand these instructions before operating the TB 220 Turf Brush. If you have any questions please contact SGM Industries, LLC at the address below. Keep these instructions in a convenient place for future reference.
  • Page 2 TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 2 of 11...
  • Page 3: Safety Information

    A concrete floor is recommended. Brace the unit to an adjacent wall to eliminate possible tipping. TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 3 of 11...
  • Page 4: Assembly And Setup

    The brushes are set in the lockout position for shipping. Please see page 5 for information on adjusting brush height. Image A Image B TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 4 of 11...
  • Page 5: General Operation

     SGM Industries, LLC recommends that the unit be stored inside when not in use. The rear bumper is designed to allow this. The unit can be rotated up into a vertical position for storage.
  • Page 6: Parts Diagram

    Parts Diagram Tire (8) removed for clarity Cover removed for clarity TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 6 of 11...
  • Page 7: Bill Of Materials

    Brush Drive Axle Weldment SGM03-306 Tensioner Shaft Weldment Not Shown SGM03-310 Control Box Harness Not Shown SGM03-311 Tow Vehicle Harness Not Shown SGM03-312 Brush Frame Harness TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 7 of 11...
  • Page 8: Electrical Schematic Diagram

    Below is the electrical schematic for the TB 220 Turf Brush. Please use this to troubleshoot any electrical issue you may have. The fuse is a 25 amp mini ATM automotive. TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 8 of 11...
  • Page 9: Maintenance

     The electrical system is protected by a 25 amp mini ATM automotive fuse, located just ahead of the red battery clip.  Repair parts are readily available from the factory. TB 220 Turf Brush Owner’s Manual Rev D Copyright 2015 SGM Industries, LLC Page 9 of 11...
  • Page 10: Declaration Of Conformity

    SGM Industries, LLC has always taken the initiative to improve its products where possible and practical to do so. SGM Industries, LLC reserves the right to make changes and improvements to the design and construction at any time without incurring the requirement to make these changes on previously manufactured products.
  • Page 11: Limited Warranty

    Limited Warranty SGM Industries, LLC (supplier) makes no representations or warranties, express or implied (including implied warranties of merchantability or fitness), except equipment shall be warranted against faulty workmanship and material for two (2) years from date of purchase. All parts supplied by other manufacturers which are used on supplier’s equipment will carry the manufacturer’s warranty only.

Table of Contents