Titan I is the outcome of 2 years development and It is a first turntable in Delta audio products range. Designed for the reproduction of natural music in conjunction of safe operation, perfect long-time stability and we are sure it will accompany you with musical pleasure for many years.
Place first the belt on the platter and then on pulley. Connect the power supply chassis to the Delta Audio turntable chassis with the umbilical cable which is provided, as shown in the fig.5 below. From power's supply output plug to the input plug on the turntable.
TITAN I User manual 2. Speed calibration Set the AUTO/MANUAL switch to MANUAL which is placed on the rear side of the turntable. Fig 6 Push the selection speed 33 button ( for regulating speed 33 rpm ) or 45 ( for regulating the speed 45 rpm ) for more than ten seconds to enter to the set-up process speed.
TITAN I User manual 3. Manual speed Operation The turntable is ready to operate after turning ON the main switch at the back side of the transformer, as shown in the fig.5 Set Auto/Manual switch which is positioned at the rear side of turntable in Manual position, as shown in the fig.7...
TITAN I User manual 4. Armboard The armboard as shown in the fig. 8 is made to accompany Linn standard tonearm between 9 – 10 in. * On demand we prepare the armboard to accommodate any tonearm (208-250 PSD ) available in the market.
User manual 7. Maintenance & Special instructions Please fill out the enclosed warranty card and return it to Delta Audio or to your local distributor / dealer. During any transportation of the turntable, always remove the platter. If this is not done, DAMAGE COULD OCCUR! Please regularly check for main leads of your turntable &...
Need help?
Do you have a question about the Titan and is the answer not in the manual?
Questions and answers