Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Bron kobold BB200
- Page 1 Operating instructions BB200 www.bron-kobold.com...
-
Page 2: Before Use
Operating instructions BB 200 Before use Please read all the information contained in these operating instructions carefully. They contain important details on the use, safety and maintenance of the lighting equipment. Keep these operating instructions in a safe place and pass them on to further users if necessary. - Page 3 Attention: Read before starting up Protect the unit from water. To ensure maximum service life of the lamp, allow it to heat up for approx. 1 minute without interruption. Always disconnect the ballast unit from the battery before cleaning or servicing and when not in use.
-
Page 4: Power Regulation
1. Starting up Connect the ballast unit to the battery. The ballast unit is designed for 30V batteries, but it can also be used with 24V batteries. In this case the output power is automatically limited to 170W maximum. The ballast unit is switched on by means of the on/off switch on the lamp. The green LED lights up (operating indicator). -
Page 5: Led Display
4. Connecting or replacing the battery The ballast unit BB 200 is available in 3 variants: with slide lock system By pressing the security mechanism at the side of the slide lock system, the battery can be inserted respectively removed. for Cannon S12 2-pole plug To connect respectively disconnect the ballast unit from the battery, tighten or release the cap nut on the plug. - Page 6 If the red LED is lit continuously the lamp must be switched off. This display is shown for a few seconds only. Then the red LED extinguishes in order to save battery current. Power = f ( U Batterie ) U Batterie (V)
-
Page 7: Technical Data
6. Technical data ________________________________________________________________________ Operation of kobold equipment with motor-generators Kobold equipment is basically suitable for operation with motor-generators provided that the supply voltage remains within the tolerance limits of 200-264V or 95-135V respectively under all load conditions (including capacitive load). Experience shows that this usually requires electronically stabilized motor-generators. When connected to unstabilized motor-generators voltage peaks of 300V and over could be observed. - Page 8 Bron Elektronik AG CH-4123 Allschwil Schweiz (Switzerland)