Table of Contents
Advertisement
NetUSB-400i USB Server User Manual
Step 2 - Connect the USB Server's Power Supply / Read the LEDs
Connect the included power supply to the USB Server's power connector (figure 2).
Once the USB Server is powered, you will notice the USB Server's red "PWR" LED
turns ON and after few seconds the yellow "RDY" LED blinks and turns ON.
The NetUSB-400i USB Server hardware installation is now complete. Please proceed to
the NetUSB-400i Utility software installation instructions.
The NetUSB-400i utility Setup is an Install Shield based application, which can be used
for installing, uninstalling and upgrading the NetUSB-400i Software.
To install the USB Server program, please double click the USB Server setup file.
6
Advertisement
Table of Contents
