3-1. Location
IMPORTANT: Mount slide so motor and cables are away from weld zone to protect from heat and spatter.
The motorized slide is normally installed onto the cross arm of a side beam opposite the side beam control. An adapter
plate is available. The MSC-2 is normally installed behind the side beam control on the cross arm. Brackets are
available.
3-2. Interconnecting And Power Cord Installation
3
5
SECTION 3 – INSTALLATION
4
1
2
3
1
Motorized Slide
2
MSC-2 Control
3
Interconnecting Cord Plug
4
Receptacle
Align keyways, insert plug into
receptacle, and tighten threaded
collar.
5
115 Volts Ac Plug
Connect
grounded and protected (time delay
fuses or circuit breakers) 115 volts
ac receptacle.
RIGHT-LEFT
4
3
Ref. ST-154 578 / ST-098 878-B / Ref. ST-154 602
plug
to
matching
UP-DOWN
OM-1096 Page 7