Download Print this page
Hide thumbs Also See for Q500:

Advertisement

Advertisement

loading

Summary of Contents for Fiilex Q500

  • Page 2: Table Of Contents

    Table of Contents What Is In The Box Specifications Basic Operation Rear Panel Interface Operation Accessories Overview Specifications For Your Safety...
  • Page 3: What Is In The Box

    What Is In The Box • Q500 Light • 4 Leaf Barndoor • 5-Inch Fresnel Lens • Cable Tie • PowerCon Cable...
  • Page 4: Specifications

    Parts Diagram Vent Holes Top Latch Size 3 Accessory Holder Magnetic Mount Light Source Focusing Knob Junior Pin Reciever Stand Locking Pin Yoke Tilt Lock Lever Handles DMX Address Knob LCD Display Yoke Bolt CCT Tuning Knob HUE Tuning Knob DMX Output (XLR Female 5-Pin) USB Port (Mini USB)
  • Page 5: Basic Operation

    The On/Off Button (20) will light green to signify it is in working mode Positioning The Q500 • To adjust the Q500, grasp the Handles (11) then loosen the Tilt Lock Lever (10). Adjust the angle to the desired position then tighten the Tilt Lock Lever (10) to secure.
  • Page 6: Rear Panel Interface Operation

    3 seconds of inactivity. When a DMX Address is set, the line will stop blinking. Once a DMX address is selected the Q500 will automatically assign the next two addresses.The Q500 assigns the addresses in this order:...
  • Page 7: Accessories Overview

    Do Not use the Magnetic Gel Holder with the Q500. SIZE 3 ACCESSORY HOL DER (3) Size 3 accessories are designed to attach to the Q500 by sliding into the Size 3 Accessory Holder (3) from the top side and then secured with the Top Latch (2).
  • Page 8: Specifications

    • Before first use, make sure to remove all protective membranes. • Do NOT use the gel holder designed for the P series of lights with the Q500. • Do NOT mount the Q500 in a hanging position without a separate safety cable.
  • Page 9 Any product, unit, or part returned to Fiilex must be packaged in a suitable manner to ensure the protection of such product, unit, or part. The package must be clearly and prominently marked with a Return Authorization Number (RA#) to indicate that the package contains returned products, units, or parts.