L
OUROE
E
LECTRONIC S
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: (818)994-6498 / FAX: (818)994-6458
sales@louroe.com / www.louroe.com
Model RN-2 is a audio mixer for combining two
microphones or two speaker/microphones into one
audio zone. It is mounted between the two
microphones and the Louroe base station or other
receiving equipment. Contains an adjustment
potentiometer for microphone balance control. The
RN-2 is phantom powered by the Louroe base station.
If the base station is not used and RN-2 is interfaced
directly with other equipment (VCR, etc.), then 12 Vdc
power must be applied to terminals A and C of either
the input or output terminal block of the RN-2.
NOTE: RN-2 is a mixer for combining two microphones or two speaker/microphones to
create a larger audio monitoring zone. Both microphones serve as one zone.
They are NOT on separate channels
WIRING REQUIREMENTS:
Microphone Only:
Louroe Verifact A, B, C, D, D-V, E, K or L-DT
Speaker Microphones:
Louroe Model TLI, TLM, TLMC, TLO, TLSP
AUDIO MICROPHONE MIXER
INSTALLATION AND OPERATING INSTRUCTIONS
WIRING REQUIREMENTS
2 Conductor shielded cable, 22
gauge with a 24 gauge drain wire
NOTE:
West Penn 452 or equivalent
WIRING REQUIREMENTS
4 Conductor consisting of:
2 Conductor shielded, 20 gauge
with 22 gauge drain (microphone
connection)
2 Conductor unshielded, 18 gauge
(speaker connection)
West Penn 356 or equivalent
RN-2
Unshielded cable is not
satisfactory for audio systems
All in the same jacket
rn-2 2/08