DeWalt DW325PT Instruction Manual page 10

seQuentIal trIP-
1. Remove mode locking pin (H), if installed.
2. Push and hold in pivot pin (I) while rotating the
selector (J) 180° clockwise to the sequential trip
position .
3. Ensure the selector is fully seated in the new
position.
to operate the nailer in sequential trip mode:
1. Depress the contact trip firmly against the work surface.
2. Depress the trigger.
WarnInG: A nail will fire each time the trigger is depressed as
long as the contact trip remains depressed.
contact trIP -
1. Remove mode locking pin, if installed.
2. Push and hold in pivot pin (I) while rotating the
selector (J) 180° counterclockwise to the
contact trip position
3. Ensure the selector is fully seated in the new
position.
to operate the nailer in contact trip mode:
1. Depress the trigger.
2. Push the contact trip against the work surface. As long as the
trigger is depressed, the tool will fire a nail every time the contact
trip is depressed. This allows the user to drive multiple nails in
sequence.
WarnInG: Do not keep trigger depressed when tool is not in use.
Loading the Tool (fig. 1, 7)
WarnInG: Keep tool pointed in a safe direction when loading
nails.
9R208191_DW325PL_DW325PT_DEWALT, FRAMING NAILER(LPF).indd 8
FIG. 5
FIG. 6
.
WarnInG: Never load nails with the contact trip or trigger
activated.
1. Hold nailer with magazine (F) tilted downward and insert
J
appropriate collated nail sticks into magazine. See tool
Specifications to determine appropriate nail sizes and angles.
2. Pull the nail pusher (E) back and carefully allow the pusher to slide
forward until it makes contact with the nails.
FIG. 7
J
Depth Setting (fig. 8)
WarnInG: Disconnect air line from
tool and remove fasteners from
magazine before making adjustments or
personal injury may result.
8
FIG. 8
G
11/14/14 3:06 PM