Equipex GL-650 UC Operation Manual

Induction warmer geoline under counter

Advertisement

Operation Manual
For
Induction Warmer
GEOLINE Under Counter
765 Westminster Street  Providence, Rhode Island 02903  U.S.A.
Tel:
(401) 273-3300
Fax: (401) 273-3328
www.equipex.com
e-mail:
service@equipex.com
9/25/15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GL-650 UC and is the answer not in the manual?

Questions and answers

Summary of Contents for Equipex GL-650 UC

  • Page 1 Operation Manual Induction Warmer GEOLINE Under Counter 765 Westminster Street  Providence, Rhode Island 02903  U.S.A. Tel: (401) 273-3300 Fax: (401) 273-3328 www.equipex.com e-mail: service@equipex.com 9/25/15...
  • Page 2: Important Safeguards

    IMPORTANT SAFEGUARDS When using electrical appliances, basic safety precautions should always be followed, including the following: 1. Read all the instructions before use. 2. The appliance should not be used to store anything. 3. Never use appliance with a cracked glass surface. If the glass surface should crack, disconnect the appliance immediately to avoid the risk of electric shock.
  • Page 3: Garanties Importantes

    GARANTIES IMPORTANTES Lorsque vous utilisez les appareils électriques, des précautions de base doivent toujours être suivies, y compris les suivants: 1. Lire toutes les instructions avant de l'utiliser. 2. L'appareil ne doit pas être utilisé pour stocker n'importe quoi. 3. Ne jamais utiliser appareil avec un fissuré surface en verre. Si la surface de verre devrait crack, débrancher l'appareil immédiatement afin d'éviter le risque de choc électrique.
  • Page 4: Installation

    INTRODUCTION The model GL-650 UC, induction warmer is designed to offer fast, high quality warming through natural solid surfaces such as granite. It is constructed of food service quality stainless steel for commercial applications, and tinted tempered (safety) vitroceramic glass. The unit requires induction ready pans to operate. The touch activated control panel is fully sealed to prevent liquid intrusion.
  • Page 5 The unit is designed to be bonded to the underside of ¾” thick granite countertop with NSF grade sealant. It should never be mounted to a steel table. The orientation of the base unit when installed should be such that the filter is accessible to be removed for cleaning (generally, removed side-to-side).
  • Page 6 Step 5: Ventilation Typical Detail To insure proper ventilation, make sure there is 13 cm (5”) between the bottom of the unit and the surface below. If necessary, a vent pipe can be added to the unit to bring cooler air directly to the air intake of the induction cooker.
  • Page 7 Step 6: Filtration Typical Detail Insert the filter. Remove and clean at least once a month: DO NOT USE THE PRODUCT WITHOUT FILTER.
  • Page 8: Operation

    ASSEMBLY The Induction Warmer comes from the factory completely assembled. It may be shipped with plastic exterior protective film, all of which must be removed before operation. DO NOT operate the appliance prior to removing the protective film completely. NE PAS faire fonctionner l'appareil avant de retirer le film de protection complètement OPERATION Touch the On/Off button, marked with the familiar vertical line within a circle symbol, to turn...
  • Page 9 hold the ‘+’ and ‘-‘ buttons simultaneously for several seconds, until the display switches over. Once a number appears in the display, the unit will begin to heat if a pan is in place, or will flash slowly if no pan is in place. The induction coil is not operating if the display is flashing. If the display flashes with a pan on the cook top, it is either not an induction ready pan or it is smaller than about 4 ¾”...
  • Page 10 You should inspect all parts on a regular basis to ensure that all is in proper working order. If a part is damaged, have the unit repaired by the manufacturer prior to returning the unit to operation. If you need any further assistance, please consult our website at http://www.equipex.com/, or call us at 1-800-649-7885 and ask for customer service.
  • Page 11 Si une pièce est endommagée, faire réparer l'appareil par un service agréé agence avant de renvoyer l'unité à l'opération. Si vous n'arrivez pas à trouver un organisme service dans votre région, veuillez consulter notre site à http://www.equipex.com/, ou appelez-nous au 1-800-649-7885 et de demander au service à la clientèle.
  • Page 12: Troubleshooting

    Troubleshooting PROBLEM POSSIBLE CAUSES ACTION A light blinks when Normal operation Nothing switching on No power when turning No power at outlet or Correct problem and test unit on outlet wiring bad again Fan runs for a few The unit is cooling down; minutes after the Nothing normal operation...
  • Page 13: Limited Warranty

    In many cases, the unit or parts requiring service may be replaced with a new or rebuilt unit/part at the discretion of Equipex. Equipex will pay for the freight both ways on the unit/part requiring service and the replacement unit/part. Customer is responsible for packing the unit/part being returned in the packaging sent by Equipex, affixing shipping labels and noting appropriate RMA designation on the exterior of the box.
  • Page 14 WARRANTIES, EXPRESSED OR IMPLIED, FOR MERCHANT ABILITY AND FOR FITNESS TOWARD A PARTICULAR PURPOSE AND CONSTITUTES THE ONLY WARRANTY MADE BY EQUIPEX, LLC. IT NEITHER ASSUMES, NOR AUTHORIZES ANY PERSON TO ASSUME FOR US, ANY OTHER LIABILITY IN CONNECTION WITH THE SALE OF THE SUBJECT EQUIPMENT.

Table of Contents