Craig cs2500 Owner's Manual

105 mm
CS2500_Eng_2013 (420 x 148mm) • 6 June 2013 • AT
SAFETY PRECAUTIONS
INFORMATION:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
1
LOCATION OF CONTROLS
1
2
5
3
6
4
7
8
9
1. FM Antenna
2. FM Dial Scale and Pointer
3. VOLUME/ON/OFF Control
4. Headphones Jack (Side of Unit)
5. TUNING Control
6. AM Dial Scale and Pointer
7. BAND Switch
8. Speaker
9. Battery Compartment (Rear of Unit)
2
INSTALLATION
1
– +
Slide the battery compartment cover to remove. Insert two (2) AA
size batteries (not included) into the compartment as the polarity
marking inside battery compartment.
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in
the battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc)
or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat
and rupture. (Follow battery manufacturer's directions.)
6. Do not dispose of batteries in fire, batteries may explode or leak.
7. Clean the battery contacts and also those of the device prior to battery
installation.
HEADPHONES:
For private listening, insert headphones into the Headphones jack. The
speaker will be disconnected.
3