Table of Contents
Advertisement
Quick Links
Before using your iConnects MicroVisor for the first time, you must charge it
continuously for approximately 3 hours, until the indicator change to green.
Please refer to the "Charging the iConnects MicroVisor" section of this manual.
Introduction
The iConnects MicroVisor is a wireless car kit based on Bluetooth® technology.
It complies with Bluetooth® 2.0 protocol, supporting Headset and Handsfree profile.
The iConnects MicroVisor has 3 buttons:
"TALK" button (main button)
"VOL+" button
"VOL-" button
1 I iConnects MicroVisor
Powerful speaker
Charging Socket
Rotary microphone
arm
VOL+ button
VOL- button
TALK button
Indicator light
Advertisement
Table of Contents
Summary of Contents for iConnects MicroVisor
- Page 1 Before using your iConnects MicroVisor for the first time, you must charge it continuously for approximately 3 hours, until the indicator change to green. Please refer to the “Charging the iConnects MicroVisor” section of this manual. Introduction The iConnects MicroVisor is a wireless car kit based on Bluetooth® technology.
- Page 2 Using the in different environment Mounting on the sun visor as a car kit When using your iConnects MicroVisor in your car, simply mount the unit onto the visor with the clip as shown in Diagram 1. Mic 1 Mic 2...
- Page 3 Charging the Connect the charging cable to the car charger and insert the car charger into the cigarette lighter socket as shown in Diagram 2. Diagram 2 3 I iConnects MicroVisor...
- Page 4 The green indicator light will turn on when the unit is fully charged. Subsequent charges should take approximately 3 hours. When the indicator light on your iConnects MicroVisor flashes in red at regular intervals (or the voice alert is activated), the unit needs to be recharged.
- Page 5 2. Switch on your phone and select its Bluetooth® discover mode (refer to the Bluetooth® mobile phone user manual). 3. When the iConnects MicroVisor is switched on, press and hold both the TALK button and the VOL+ button for about 5 seconds until the indicator light flashes red and blue alternately.
- Page 6 Switching the ON and OFF Switching the Switch on the iConnects MicroVisor by lifting up the microphone arm as shown in Diagram 4. You will hear a beep (2 tones) in the speaker (and continuous connecting beeps until it is connected to the handset).
-
Page 7: Making A Call
For some phones, you may need to press “Connect” on the phone. When your is ON Press once on the TALK button to take the call. 7 I iConnects MicroVisor... -
Page 8: Ending A Call
Press once on the TALK button to end an active call. Adjusting the volume To increase the volume during an active call, press the “VOL+” button on the iConnects MicroVisor To decrease the volume during an active call, press the “VOL-“ button on the iConnects... - Page 9 With a phone in Headset Profile During an active call, to transfer it to the phone, simply turn off your iConnects MicroVisor With a phone in Hands-Free Profile During an active call, to transfer it to the phone, double click on the TALK button.
-
Page 10: Call Waiting
To switch between an active call and a held call, press the TALK button on the iConnects MicroVisor approximately 2 seconds. To end the active call and take the held call, press the TALK button once on the iConnects MicroVisor.