Table of Contents
Advertisement
Table 2-6 lists the options you must select to enable the PPTP protocol.
Parameter
IP Address
Subnet Mask
Default Gateway
User ID
Password
PPTP Gateway
Idle Time Out
Back button
OK button
Table 2-6. PPTP parameters.
Type in the IP address that your ISP has given you to
establish a PPTP connection.
Type in the subnet mask provided by your ISP
(for example, 255.255.255.0).
Type in the ISP gateway's IP address.
Type in the user name provided by your ISP for the
PPTP connection. This is sometimes called a
connection ID.
Type in the password provided by your ISP for the
PPTP connection.
If your LAN has a PPTP gateway, then type in that
PPTP gateway IP address here. If you do not have a
PPTP gateway, then enter the ISP's Gateway IP
address.
You can type in an idle time threshold (minutes) for
the WAN port. This means that if no packets have
been sent (no one is using the Internet) throughout
this specified period, then the router will automatically
disconnect the connection with your ISP.
Click on this button to go back to the previous screen.
Click on this button to save your changes and go on
to the next screen.
CHAPTER 2: Quick Setup Wizard
Description
17
Advertisement
Table of Contents
