Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Xplorer 3D PRO
- Page 1 QUICK START GUIDE FOR USING XPLORER 3D PRO...
- Page 3 WELCOME XPLORERS! This the Quick Start Guide for using your XPLORER 3D PRO You can find updated versions of this guide on our website, at WWW.XPLORER3D.COM, where you can get in touch with Customer Service if you have any questions.
- Page 5 INDEX 1. SAFETY INFORMATION 2. TECHNICAL SPECIFICATIONS 3. UNPACKING AND INSTALLING XPLORER 3D PRO...
- Page 6 Directives document (https://www.xplorer3d.com/blogs) The most relevant aspect to guarantee print quality is calibrating Xplorer 3D PRO. Proper calibration is essential to performance and to ensure the desired results. Poor calibration may keep you from printing the object you wish to make.
-
Page 7: Safety Informaton
1. SAFETY INFORMATON... -
Page 8: Safety Information
7 - Modifications to XPLORER 3D PRO: if you modify XPLORER 3D PRO in any way, this will immediately void the warranty. If you still wish to modify it, get in touch with us, explain... -
Page 9: Technical Specifications
2. TECHNICAL SPECIFICATIONS... - Page 10 1. TECHNICAL SPECIFICATIONS Printing technology Max. Printing volume 200mm X 200mm X 200mm [7.9” x 7.9” x 7.9”] Layer resolution High - 100 micron Low - 300 micron Filament diameter 1.75mm Volume 40cm X 40cm X 45cm Approx. Weight 16.5KG [36.3lb] Working ambient temperature 15º...
- Page 11 3. UNPACKING AND INSTALLING XPLORER 3D PRO...
- Page 12 2. Remove the printer by holding the top frame 3. Carefully remove the protective packaging 4. Check to make sure the box contains the following items: 1 Xplorer 3D PRO 1 Printing Bed‟s Glass 1 Tweezers 1 Allen key Set...
- Page 13 XPLORER 3D PRO DIAGRAM Filament entry Extruder Extruder nozzle Print Bed Calibration screws ON/OFF switch Control Buttons LED Display Mini USB SD CARD mount LEFT SIDE...
- Page 14 1. Make sure you‟ve removed all the printer‟s packaging material and check to see if the main switch is in the “off” position. 2. Attach the power cable, connecting it first to the XPLORER 3D PRO printer, and next, to the socket.
- Page 15 3. Connect the USB cable to XPLORER 3D PRO and to the computer. 4. Place one, and only one, layer of Adhesive tape on the printer bed Glass, carefully to avoid any overlapping. 5. Place the spool inside the spool mount. Take care to keep the filament wound tight, because any looseness might cause kinks or knots to appear in the filament, which makes printing impossible.
-
Page 16: How To Print
2. Make sure the adhesive tape is in an acceptable state. If it‟s damaged, it should be replaced as described in point 4 of „Installing XPLORER 3D PRO‟. 3. Check to see if no kind of object or filament debris is on the printer table. -
Page 17: After Printing
Don‟t forget to replace the tape before printing again. TROUBLESHOOTING We recommend you read our FAQ and Troubleshooting pages available on the website www.Xplorer 3D.com. If you can‟t find the solution to a given problem, please contact Customer Support by using the form available on the aforementioned website. - Page 18 © XPLORER 3D PAKISTAN. www.Xplorer3D.com All rights reserved.