Safety Rules This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. Read and understand all safety rules and operating instructions before using this tractor attachment.
Page 4
Assembly Instructions Attach Control Drawbar loosely to Spreader Body with hardware as shown. MAKE SURE WIRE BRACE IS BELOW DRAWBAR BEFORE ATTACHING ANY HARDWARE. Attach Wire Brace and Brace Clip to Drawbar with hardware as shown. Tighten all hardware at this time. Install Hitch Pin as shown and secure with Cotter Pin.
Operating Instructions Before Using Broadcast Spreader: Read all Safety Rules found on page 1. Make sure the drop holes in the bottom of the hopper are fully open with the Rate Control handle set on #30. If not, adjust control cable to allow for a fully open hopper at position #30.
Page 6
Operating Instructions BROADCAST SPREADER SETTING MATRIX Look for EarthWay or Ev-N-Spred models on the bag for settings. If there is none listed, please use the comparison chart below as a guide to estimate your spreader setting. These settings are approximate and intended as a guide only. Variations in physical characteristics of material applied, speed and surface roughness may require slightly different spreader settings.
In the space below record the purchase date of your Spreader. Model Number 80TBS Purchase Date Keep this Owner's Manual and your receipt in a safe place for future reference. After the five year warranty period all replacement parts may be ordered by...
Page 10
DESIGNED AND TESTED IN COLUMBUS, OHIO MANUFACTURED IN THE U.S.A. FROM DOMESTIC AND IMPORTED COMPONENTS MODEL # 80TBS www.OHIOSTEEL.com (800) 652-2321...