Do you have a question about the 2HP24V and is the answer not in the manual?
Questions and answers
Summary of Contents for all4solar 2HP24V
Page 1
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar Distribution: all4solar ABN 61 832 274 764 123 Harbour Drive | Trinity Park 4879 (Australia) 0400275866 | info@all4solar.com.au |www.all4solar.com.au Operator’s Manual Version 2.0 Electric Solar Outboard Motor System 2HP24V “plug &...
Page 2
This manual has been compiled to help you install and operate your all4solar outboard motor system with safety and pleasure. It contains details about the motor, the solar panel and the batteries as well as for all equipment supplied and information on its installation, operation and maintenance.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar Contents 1) Hazard communication ..........................4 Hazard signs ..........................4 Unpacking ............................4 Eligibility of the boat ........................5 Preparation of material ........................5 2) Installation on the boat ..........................6 Installation to the transom ......................
Indicates important information for a safe and easy operation or highlights special circumstances. For any third party equipment not supplied by all4solar read the operations and instructions manual as well as the safety recommendations of those suppliers. If at any point you do not understand this documentation or explanations seem unclear, do not proceed the...
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar Parts supplied (depends on type of order) FULL KIT: 1 outboard trolling motor 24 V / 1150 W output / 1250 W input 1 propeller, stick and nut...
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar WARNING The incorrect connection of plugs can cause short circuits, injuries and damages to the system. Do not expose the batteries, main switch / fuse and plugs to water.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar INFORMATION Secure the motor to the hull with a cable to the mounting bracket to prevent loss during installation or de- installation process. Electric power supply...
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar Safety sticker The following safety sticker is recommended to be fixed to the system close to the main switch. The operator is responsible for a safe installation, operation and proper indication of any dangerous parts.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar Fully extend the cable fixed to the main board and connect to the solarpanel with the black plug. The solarpanel produces electricity as soon as there is light shining on the panels. So only connect to the main switch, if the batteries are installed as per instructions.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar State of battery charge Charge lights Connections: + solar 24 C / - solar 24 V / + battery 24 V / - battery 24 V / (load +/- 24 V) 3.3) Display &...
4) Area of operation The 2HP24V trolling motor is suitable to move small boats. Do not use this system on open waters or in stormy conditions or as main propulsion system for larger boats. Always have paddles in the boat.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar 5.1) Turn-on procedure Turn-on the battery main switch The battery charge indicater LED should light up Turn tiller handle to the position “1 forward” or “1 reverse”...
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar 5.4) Trim the motor CAUTION Raise or lower the engine with care to avoid damage to the composite tube (shaft). The angle of the motor can be adjusted by pushing the lever towards the shaft.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar 5.5) Main fuse The connection from the battery to the motor and the solar system is secured by a 100 A fuse which is installed parallel to the main switch on the main board.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar 6.2) Service chart Shedule by Operator By operator with by manufacturer genuine parts After each trip Flush the motor with fresh water if used in salt...
Transport to all4solar is to be paid by customer. The redelivery to the customer is paid by is to be paid by customer. The redelivery to the customer is paid by is to be paid by customer.
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar 9.3 Solar system Specifications Solarpanels (two 12 V panels in series / Aluminium frame / 3 mm glass) Maximum output (Pmax) 90 W Voltage at pmax...
Page 18
2HP24V outboard motor operator’s manual Version 2.0 EN | 01.01.2015 | copyright by all4solar...
Need help?
Do you have a question about the 2HP24V and is the answer not in the manual?
Questions and answers