Summary of Contents for Tactical Impulse LE-1
- Page 1 Rev 1.05 www.tacticalimpulse.com Patent Pending © 2013 Tactical Impulse, All Rights Reserved.
-
Page 2: Table Of Contents
Switch Operation ........5 Charging Options ........... 7 Modular Tail Accessories ........7 Smart Light Control (SLC) ........8 User Programming ..........8 Care and Maintenance .......... 9 Safety Advisories ..........10 LIMITED LIFETIME WARRANTY......11 LE-1 Flashlight – User Guide | 2... -
Page 3: What's In The Box
1. Switch 1 5. Main Barrel 2. Switch 2 6. Locking Notch 3. Tactical Tail-cap 7. Stainless Steel Strike Bezel 4. Charging Rings 8. Battery Holder ❼ ❺ ❹ ❶ ❻ ❸ ❽ ❺ ❷ LE-1 Flashlight – User Guide | 3... -
Page 4: Battery Installation
After the battery has been successfully inserted into the battery holder, the battery holder may be inserted into the LE-1 Main Barrel. An arrow and the word, “INSERT”, are marked on the backside of the battery holder. These markings indicate the correct direction in which the battery holder should be inserted into the Main Barrel. -
Page 5: Battery Removal
Switch 1 or 2 will power the light OFF. Momentary – Partially depressing Switch 1 or 2 (half- press) will result in momentary light activation (i.e. light will only remain ON while pressure is applied to the switch) LE-1 Flashlight – User Guide | 5... - Page 6 ON, it will use the mode that was in-use when the light was previously powered OFF. NOTE: The LE-1 is programmed by default to power ON in HIGH mode every time. However, the LE-1 may be easily programmed to use mode-memory by following the User Programming instructions.
-
Page 7: Charging Options
The Tactical Impulse 18650 3100 mAh Li-ion battery may be recharged within the LE-1 using the Tactical Impulse LE-1 Cradle Charger *. The battery may also be removed from the LE-1 and recharged using a supplied or approved Tactical Impulse 18650 battery charger. -
Page 8: Smart Light Control (Slc) Tm
User Programming The LE-1 is programmed by default to power ON in HIGH mode every time. The LE-1 may also power ON in the last operating light mode (mode-memory). To toggle between the two programs, follow the steps below: 1. -
Page 9: Care And Maintenance
4. The LE-1 light will begin to flash when the operating program is being updated, and the switches should be released. * LE-1 Cradle Charger and Smart Holster sold separately. Care and Maintenance Do not expose the unit to acidic or caustic substances. -
Page 10: Safety Advisories
Do not use any other device to charge the LE-1 other than a Tactical Impulse approved charger! Do not use any battery to power the LE-1 other than a Tactical Impulse supplied or approved battery! Never short-circuit the charging contacts on the battery... -
Page 11: Limited Lifetime Warranty
TACTICAL IMPULSE will replace or refund, at its option, the purchase price of any... - Page 12 Check for updated versions at: http://tacticalimpulse.com/products/documentation/le-1.pdf...
Need help?
Do you have a question about the LE-1 and is the answer not in the manual?
Questions and answers