Hotpoint CSM22GRD WW Owner's Manual page 21

Leveling Rollers
Remove the base grille by pulling it out of the bottom. Follow the directions that apply to your model.
On some models
On some models
These rollers have 2 purposes:
1 The rollers can be adjusted so the
refrigerator is firmly positioned on
the floor and does not rock back
and forth.
2 Rollers allow you to move the
refrigerator away from the wall for
cleaning.
Turn the two front roller adjusting
screws clockwise to raise the refrigerator,
counterclockwise to lower it. Use a 3/8"
socket wrench, adjustable wrench or
pliers.
Built-In Style models also have rear
adjustable rollers so you can align the
refrigerator with your kitchen cabinets.
Use a 5/16" socket wrench to turn the
screws for the rear rollers— clockwise to
raise it, counterclockwise to lower it.
To replace the base grille, line up the
clips on the back of the grille with the
openings in the baseplate and push the
grille forward until it snaps into place.
These rollers have 3 purposes:
Rollers adjust so the door closes
1
easily when opened about halfway.
[Raise the front about 5/8" (15 mm)
from the floor.]
To assure that the doors will close
automatically from a halfway open
position, there is a built-in tilt from the
front to the back of the cabinet. Side-by-
side refrigerators also have specially
designed door hinges that lift both doors
slightly when opened, allowing the force
of gravity to help close them securely.
Rollers adjust so the refrigerator is
2
firmly positioned on the floor and
does not wobble.
3 Rollers allow you to move the
refrigerator away from the wall for
cleaning.
Front Roller
Adjusting Screw
Rear Roller Adjusting Screw (on Built-In
Style models only). Use this screw if the
refrigerator has one.
Front Roller
Adjusting Screw
Rear Roller Adjusting Screw (on Built-In
Style models only). Use this screw if the
refrigerator does not have the screw
pictured to the left.
Turn the roller adjusting screws
clockwise to raise the refrigerator,
counterclockwise to lower it. Use an
adjustable wrench (3/8" hex head bolt)
or pliers.
To replace base grille, align prongs on
back of grille with clamps in cabinet
and push forward until grille snaps
into place.
21